Load cable generally means the final cable before the actual load. So on a clothes dryer the "Load Cable" would be the cable running from the outlet to the actual clothes dryer.
To answer this question the size of the cable or the amperage of the load is needed to calculate the correct wire size and connectors to fit the cable.
With a constant voltage and increase in wire length will increase the end to end resistance and therefore the current will decrease.
1.6mm or 14awg
The length of the cable is determined by the distance from the center of the distribution panel to the center of the load.
if your load draws a max of 15 amps then you would use 14-16 gauge wire. the lower the gauge the more current that is allowed to pass. there are charts that show max current for diameter of wire
Load cable generally means the final cable before the actual load. So on a clothes dryer the "Load Cable" would be the cable running from the outlet to the actual clothes dryer.
300sqmm cable i will use
yes
To calculate the cable size for a 100 kW load, you would need to consider factors such as the voltage of the system, the type of cable insulation, the ambient temperature, and the installation method. The cable size is typically determined by the maximum current the cable will carry without overheating. Using the formula: Cable size (mm²) = (2 x L x I x R) / (√3 x V x cosΦ), where L is the cable length, I is the load current, R is the resistance of the cable, V is the voltage, and cosΦ is the power factor, you can calculate the appropriate cable size for the 100 kW load.
A "live" cable is used to supply a voltage potential to a load.
The purpose of a cable puller is to allow a system of wires to pull a heavier load. A cable puller will then be used to feed the cable through on this system.
To answer this question the size of the cable or the amperage of the load is needed to calculate the correct wire size and connectors to fit the cable.
You can determine how strong your cable is through cable attachments by finding a weight load guideline online. It shows if the cable attachment is strong enough to support the cable.
With a constant voltage and increase in wire length will increase the end to end resistance and therefore the current will decrease.
simply because there is load on that source
refer to ANSI lor..
1.6mm or 14awg