Wiki User
∙ 12y agothe SCT is used to provide excitation during short circuit conditions. under Short Circuit the voltage may drop below threshold level causing field current to drop, to avoid over excitation by the AVR, the short circuit provides the excitation energy required to maintain a voltage that allows protective devices to operate and isolate the fault.
the SCT is open under normal operating condition
Wiki User
∙ 12y agoWith a transformer...
why does have to short-circuit secondary wire of current transformer ?
The transformer can be tested on open and short circuit to find the iron losses and copper losses separately, which uses a fraction of the power than having to run the transformer on full-load.
transformer is busted; if input voltage is normal you have short circuit or open circuit somewhere
Not clear what your question is. First of all, circuits are not classified as DC and AC. Circuits are what they are, and you can apply either AC or DC to any circuit. However, considering a circuit that was designed only for use with DC applied. Still your question is unclear. What is transformer action? "Transformer Action" happens in a transformer.
A transformer is used to increase or decrease the voltage in an electric circuit. It consists of two or more coils of wire that are used to transfer electrical energy by mutual induction between the coils.
what is the function of transformer in the half wave rectifier circuit
These two tests are performed on a transformer to determine (i) equivalent circuit of transformer(ii)voltage regulation of transformer(iii) efficiency of transformer. The power required for theseOpen Circuit test and Short Circuit test on transformeris equal to the power loss occurring in the transformer.
With a transformer...
With a transformer...
Short circuit test and open circuit test are widely used to test the efficiency of the transformer.
why does have to short-circuit secondary wire of current transformer ?
P0001 Fuel Volume Regulator Control Circuit/Open.P0001 Fuel Volume Regulator Control Circuit/Open.
A transformer is used to transfer electricity from one circuit to another.
It is called a rheostat, it is a variable transformer
The transformer can be tested on open and short circuit to find the iron losses and copper losses separately, which uses a fraction of the power than having to run the transformer on full-load.
In series to every phase winding of transformer.