Primary substation - when the transformer is HV/MV or MV/MV. e.g. substation designed for 132kV/33kV or 230kV/22kV or 33kV/11kV etc
stepped down for MV distribution (mainly for utilities and heacy industries)
Secondary substation - when the transformer is HV/LV or MV/LV. e.g. substation designed for 11kV/400V or 6.6kV/400V etc
stepped down for LV distribution (mainly for residential, commercial) sometime referred to as a kiosk substation.
132kV substation is part of transmission and distribution of power in which the transmission voltage is 132kV. The substation is for stepping down or stepping up of the voltages to the required voltage. the substation also serves as a place where the transmission lines can be isolated, controlled and monitored. The substation consists of different equipment that is used to regulate, monitor and distribute the required power.Another AnswerIn the UK, 132 kV voltages are considered to be the lowest transmission voltages. Other transmission voltages are 275 kV and 400 kV. A '132-kV substation' is normally one in which this voltage is stepped down to a primary distribution voltage, usually 33 kV but, sometimes, 66 kV. As the previous answer points out, substations contain transformers, switchgear, busbars, and protection equipment.
A substation is not a load but is a place where switching and voltage-level changing takes place. Accordingly, you cannot apply a 'power factor' to a substation.
no
the first GIS substation installed in India at pophali (koyana hydro project in Maharashtra in 1992.)
Batteries are essential components in a substation. They provide the (tripping) current by which protective relays can trip high-voltage circuit breakers in the event of a fault. This means that the circuit breakers can trip even if the substation itself has lost its ancillary AC power supply.
Many substation transformers have three windings - the primary, secondary, and tertiary. The tertiary bus is the bus connected to the tertiary of the transformer. this is often used as station power for the substation, since the tertiary is very often a distribution level voltage (2 - 15kV).
A substation that is smaller than the average substation. A substation converts electric power from one voltage to another.
The Substation which comes power from the power plant know as pooling substation.
Jefferson Substation was created in 1909.
Neuhof Substation was created in 1985.
Concourse Yard Substation was created in 1933.
In my line of work that is an Electrical High Voltage substation that is brand new. It is being built from a green field into an energized fully functional substation yard. There is no existing substation or remodeling of an existing one being done.
132kV substation is part of transmission and distribution of power in which the transmission voltage is 132kV. The substation is for stepping down or stepping up of the voltages to the required voltage. the substation also serves as a place where the transmission lines can be isolated, controlled and monitored. The substation consists of different equipment that is used to regulate, monitor and distribute the required power.Another AnswerIn the UK, 132 kV voltages are considered to be the lowest transmission voltages. Other transmission voltages are 275 kV and 400 kV. A '132-kV substation' is normally one in which this voltage is stepped down to a primary distribution voltage, usually 33 kV but, sometimes, 66 kV. As the previous answer points out, substations contain transformers, switchgear, busbars, and protection equipment.
The world biggest distribution substation is in DELHI TRANS CO .
$2,967,000 is the recommended value to built an electric substation.
Saskatoon Electrical System Substation was created in 1929.
Portland Railroad Company Substation was created in 1911.