0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What type of resistor is used for automotive circuits?
Which type of resistor is commonly used in automotive circuits?
What is current tracer?
A current tracer is apen like device used to test the dead circuits. It is used to troubleshhot the logical circuits
Where the first integrated circuits used?
in America
What is used to open and close circuits?
a switch.
What voltage is used for control circuits?
voltage
What size conductors are to be used small appliance branch circuits?
All small appliance branch circuits, typically kitchen, are required to be 12awg. Cu., or 20 amp.
What is an electric cable?
"Cable" most often refers to a wiring method manufactured with more than one conductor. Examples would be the triplex (3 twisted wires) that powers most homes and the NM cable used for branch circuits in homes. But I have heard of single conductors referred to as cables, probably because of their size.
What is the largest mm twin and earth cable available?
The largest size of twin and earth cable available is typically 16mm² in the UK market. This size is commonly used for higher current applications such as cooker circuits or shower circuits.
Service entrance cable underground feeder branch circuit cable mineral insulated cable jacketed cable?
These are different types of electrical cables used for various applications. Service entrance cable is used to connect the utility power to a building's main electrical panel. Underground feeder branch circuit cable is used for underground wiring between buildings or from the main panel to subpanels. Mineral insulated cable is a type of fire-resistant cable used in high-temperature environments. Jacketed cable refers to any cable with an outer protective covering for mechanical and environmental protection.
What are scopes in electronic and communications engnieering?
Electronics and communication is a branch of engineering which deals with electronic devices, circuits and various communication methods. Several instruments or equipment used for the above purpose is also dealt in this branch. The scope of this branch isVLSIEmbedded SystemsCommunication networks.
Can parallel circuits be used instead of fuses?
No. Parallel circuits are not fuses. Fuses can be used to protect parallel circuits.
What is the tap off in cable network?
Tap off in cable networks is a point in the network where a branch cable is connected in order to connect a customer or a subscriber. It is usually done by a splitter or a coupler. Tap off points are also used to measure the signal strength or to monitor the quality of the transmission. The tap off point is usually connected from the main trunk cable to the side branch cable. Tap off points are also used to connect amplifiers and other devices in the network. Tap off points are used to connect branch cables to the main trunk cable. Tap off points can be used to measure signal strength or monitor transmission quality. Amplifiers and other devices can be connected to tap off points.
What is electrical feeder?
An electrical feeder is a cable or conductor that carries electric power from a distribution panel to different circuits or loads in a building or facility. It plays a critical role in distributing electricity efficiently and safely to various parts of a system. Feeder circuits are typically protected by overcurrent devices such as circuit breakers or fuses to prevent overload and short circuits.
What are 3 type of electrical circuit?
Lighting CircuitsRadial CircuitsRing circuitsRing CircuitsA ring circuit can serve an area up to 110 square metres (120 square yards), 2.5mm2 cable is used to wire the circuit and the circuit has a 30amp fuse or 32amp MCB on the consumer unit. It is usual for a house to have one ring circuit upstairs and one ring circuit downstairs.Ring circuits can have extra sockets added to them by adding a 'spur' onto a ring circuit. A spur is a branch off the ring circuit, usually from an existing circuit, although a junction box could also be used. Theoretically as many spurs as sockets could be added, but the maximum load of the circuit (30/32amp) still exists).Radial CircuitsRadial circuits can therefore only serve a smaller area. Using 2.5mm2 cable combined with a 20amp fuse/MCB an area of 20 square metres (24 square yards) is permissible. For 4mm2 cable combined with a 32amp MCB or a 30amp cartridge fuse (a re-wirable fuse is not allowed) an area of 50 square metres (60 square yards) is permissible.In a similar way to ring circuits spurs can be added at points along the radial circuit if required. High powered appliances (cookers / showers) must have their own radial circuit.Lighting CircuitsLighting circuits are basically radial circuits. There are two distinct types of lighting, circuit the loop-in circuit and the older junction box circuit. Most houses combine aspects of both types of circuits. The loop-in circuit has a cable, running from light to light terminating at the last light as in the conventional radial circuits and then single cable run from the lights to the light switches.The other type of lighting circuit has a junction box for each light. The cable runs from the consumer unit to the first junction box and then onto the next terminating at the last junction box. Then another cable is run from each junction box to its light and another wire from the junction box to that light switch. The cable used for a lighting circuit is 1mm2 or 1.5mm2 for long runs.Another AnswerI think that this question is referring to more fundamental circuits than those described above. There are fourcategories of circuit: series circuits, parallel circuits, a combination of the two (series-parallel circuits), and complex circuits. Complex circuits describe circuits which don't fall into the first three categories.
Where are simple circuits used?
Simple electronic circuits are used in simple electronic devices.
How is electricity distributed to lights and power sockets?
It depends where you live.In most countries, radial circuits are used for both power and lighting circuit.In the UK, ring-main circuits are used for power circuits, while radial circuits are used for lighting circuits.
What size breaker is used for a 5 ton 34 amp minimum 60 amp maximum?
60 amp using AWG # 6 copper for branch circuits.
