0
Add your answer:
Earn +20 pts
Can you make a sentence with the word screw?
I'd like to see what a number 10 screw would do for that hinge.
A screwdriver placed across two wires in a circuit creates a circuit?
Depending on where in the circuit the screw driver is placed it could be used as a switch or it could short the circuit out.
What will hold two boards together better a screw or a nail?
A screw.
Is hardware one word or two?
One word: hardware
Is corkscrews simple machines?
Screw
Is screw driver one word and two words?
"Screwdriver" is typically written as one word when referring to the tool used to tighten or loosen screws. However, it can also be written as two separate words, "screw driver," when referring to a person who drives screws for a living.
How do you get to the parking light assembly on a 93 Landcruiser in order to change the bulb?
very simple, three screw you must take out. the front outside(phillip screw driver) and the two screw on the side(hex driver)
Another word for screw up?
Mistake and fault are two other words for screw up.
What sizes are typically included in a screw driver set?
A basic screw driver set suitable for home use contains about six tools. The 6-piece Stanley set is typical, containing two each of 1/4 inch and 3/16 inch flat screw drivers with different lengths, and two Phillips screw drivers with head sizes of 1 point and 2 point.
How do you replace a headlamp on 1998 subaru impreza?
remove grill by sticking screw driver down holes on the top , remove side light with star screw driver and remove the four 10 mm bolts (two at each side)
What is the compound word in this sentence -- The bus driver took an alternate route to the airport?
Compound words are two words combined into one. Since "airport" is made of two words-- air+port, it is a compound word.'Bus driver' is also considered a compound word, in the open form.
How do you change a 1995 325 i BMW hood sign?
Get a screw driver & a rag. Wrap the rag around the screw driver & get it under the roundel (you may need something even skinnier to it up a little extra to fit in the screw driver)... With enough force you will pop it out of the grommets holding it in. Just don't go crazy, take your time. To get another roundel on you should get two new grommets (quite cheap) and put them on the replacement one. Line it up with the holes & start pushing.
How do you disassemble front hub on 1985 Ford F-250?
If it's independent it's real easy Allen wrench regular screw driver c clip tool then you will see a fillip screw don't take it out it all comes out in one it mite take two regular screw drivers to pull it out then there will be two bearings and a lock nut do it one side at a time the first time I did it I took pics as I took it apart in case
Can you make a sentence with the word screw?
I'd like to see what a number 10 screw would do for that hinge.
What do you call the distance between two threads in a screw?
The distance between two threads in a screw is called the pitch. It is the measurement of how far the screw advances with one complete turn.
If driver one may have ran a red light and hit driver two but driver two is unlicensed in the state of Texas who is at fault?
Both can be charged. Driver one: running a red light and colliding. Driver two: operating without a drivers license. (personal opinion: Driver one's insurance company is going to have to pay.)
How do you change the license plate light on a 1998 Ford Mustang?
Using a small Phillips head screw driver un screw the two screws holding on the cover and the cahnge the bulb by simply pulling it out.
