b'coz at the secondary side large amount of current flow by recarding of active component or other ckt. which is connected to the secondary side so that ckt. is not damage or burned by flowing large amount .. load is connected at the secondary side .AnswerThe 'primary' winding of a transformer is, by definition, whichever winding is connected to the supply, whereas the 'secondary' winding is whichever winding is connected to the load. This does not mean that a load MUST be connected to a transformer, as it will work 'off load' -that is, with no load connected- without any harm.
To the load !
Hi, First understand one thing seriously!! The transformer only can be rated in KVA. Bcoz, its power factor not depends on the load connected.
since we need to get desired or rated voltage, so if it is connected in high voltage side of the transformer, voltage supply will be more, and hence the current will be more than the required amount. this is the reason why the instruments re connected at the low voltage of the transformer while performing no load test.
There's very little point in having a distribution transformer if its secondary winding isn't connected to a load! So, to answer your question, a 'secondary system' (by which you, presumably, mean 'load'), isn't 'essential' to a distribution transformer, it could just sit there doing nothing!
It is connected to the secondary side.
A transformer is fundamentally a set of coils; therefore, a transformer is an inductive load. However, by "transformer load", you seem to mean "the load that is connected to a transformer". Whether that load is inductive or capacitive depends mostly on what is hooked up to the transformer.
The primary winding of a transformer is connected to the supply, while the secondary winding is connected to the load.
The load is connected to the transformer's secondarywinding, while the primary winding is connected to the supply. The terms, 'primary' and 'secondary', do NOT relate to voltage levels.
The load side of a transformer feeds the device, such as a light or motor. It is the output of the transformer. The input, or line side, provides the voltage that is to be transformed, either up or down, to supply the load side.AnswerA transformer's primary winding is connected to the supply voltage, and the secondary winding is connected to the load.
A normal transformer should not blow the primary side breaker when it is not connected to a load on the secondary. If it does, something is wrong. Check for shorted or burned windings. Make sure that it is indeed disconnected from the load - it might still be connected to something that is also presenting a fault.
b'coz at the secondary side large amount of current flow by recarding of active component or other ckt. which is connected to the secondary side so that ckt. is not damage or burned by flowing large amount .. load is connected at the secondary side .AnswerThe 'primary' winding of a transformer is, by definition, whichever winding is connected to the supply, whereas the 'secondary' winding is whichever winding is connected to the load. This does not mean that a load MUST be connected to a transformer, as it will work 'off load' -that is, with no load connected- without any harm.
Hope this helpsAn "OFF-Load tap transformer" can only have it's tap adjusted when it is De-energized,while the "On-Load tap transformer" can adjust its tap under load conditions.Kind RegardsHammad KhanUniversity of Western AustraliaAnswerAn 'off load' transformer is one whose secondary is open circuited, and not supplying a load. An 'on load' (not 'load') transformer is one that is connected to a load.
All transformers have a power rating given in kVA which determine the maximum load that can be connected to that transformer.
To the load !
If transformer then it refers to that, the primary is charged, but secondary is open, (no load is connected) If motor, it refers to that no load is connected to motor, the shaft is decoupled from the load, but running with out any load.
A winding is the name given each of the coils wound around the transformer's core. A basic transformer has two windings, termed the primary winding (connected to the supply) and the secondary winding (connected to the load).