How much temperature can IS 2062 can withstand
16kv
25 kV.A for a permanent load; more if the load is variable.
BIL is basic insulation level as per you or in other words it would be "basic impulse level" which implies the limit up to which an insulator could withstand impulse due to lightning strikes. Impulse is generated on the insulation due to the high voltage surges and spikes due to lightning strikes. BIL is generally much higher as compared to power frequency withstand voltage. In other words BIL is lightning Impulse withstand voltage. Impulse withstand voltage is the voltage that is generated due to switching operation and it's much higher than power frequency withstand, but BIL or the lightning withstand voltage is a the voltage level that an insulation can withstand during surge or lightning strikes.
275
What is a Feist dog? For your answer, how much cold can you withstand? Then that is your answer.
Depends upon how many amps you need at the load and whether you're using copper or aluminum or some other material, and how much voltage drop your load can withstand during startup inrush.
any amount, about how much you can withstand
A femur bone can withstand roughly 4000 N of force.
An eggshell can withstand a lot more pressure than people think. It can withstand the force of 6.2 pounds or 25 Newtons.
How much temperature can IS 2062 can withstand
too much load
2x6x12 load
It is resistive much load
16kv
when you connect the rcas to a 1 channel (mono) amp. the signal from the left rca and right rca is combined to give you a mono signal. that signal is then amplified and sent out through the one channel. a 2 channel amp will send the signal from the left rca to one channel and the signal from the right to the other channel. mono amps are usually used to power subwoofers. 2 channel and 4 channel amps are usually used to power speakers 5 channel amps are usually ment to power speakers plus a subwoofer/subwoofers 2 channel amps are also used to power subwoofers in different situations. if you have one subwoofer with a 4 ohm impendance your better off powering that sub with a 2 channel amp instead of a mono amp. this is because you can "bridge" the 2 channels for this sub which will put a 2 ohm load on each channel. which theoretically means it will put out twice as much power as it would compared to if it had a 4 ohm load on each channel. this means that you can buy a less powerful amp which will be cheaper for you, and also smaller, so it will take up less space.. a big bonus in car audio. bridging is simply using both channels for one load (sub/s), this is done by connecting the pos. wire to the pos. output of one channel and connecting the neg. wire to the neg. ouput of the other channel. pretty much every amplifier in production nowadays is bridgable.
250.00 a load