0
Add your answer:
Earn +20 pts
What pumps are used in petrol pumps?
Gear Pump.Additional answerI very much doubt if gear pumps are used in any petrol car because of the lack of lubrication. Much more likely is a diaphragm pump, which is certainly used on a lot of cars.
How much teflon tape?
The use of PTFE tape depends on the what you'll be using it for. PVC products dont need as much as what a brass or copper fitting may require
What is the purpose of retracting landing gear's pivot?
When the landing gear retracts, it is very important for aerodynamics that they retract into the body of the aircraft as much as possible. However, placement of the landing gear depends ultimately on factors such as the aircraft's center of gravity, its weight, its possible fuel load and much more, there may not be a good locaction in the aircraft for the wheels to rectract fully without some kind of articulation. As a result, aircraft designers often must come up with some pretty interesting solutions to enable to landing gear to be retracted fully into a space that is otherwise unused in the aircraft. Often in order for the landing gear to retract into its well, the wheel trucks may have to be rotated or pivoted. Large aircraft in particular often have multiple wheels for each of the landing gear. It is particularly difficult to design a retraction system for these as the wheel trucks may be very large and ungainly. Some large aircraft have the ability to pivot the landing gear to one direction or another for landing. This is done to increase the aircraft's capacity to land in cross-winds. In a strong cross-wind the aircraft may not be able to land gracefully pointed straight down the runway, and so the landing gear may be off-set one direction or another to allow the aircraft to land with a slight crab-angle.
How many amperes will a 28-volt generator be required to supply to a circuit containing five lamps?
It depends on how much power the lamps require, and on how they are connected.
Do you need mathematics and physical science to be an engineer?
Yes. Pretty much any collage program for engineering will require you to take higher level math and physics classes.
How much gear oil does a 2003 Yamaha Blaster need?
should be alittle more than a half of a quart
How much gear oil in a Yamaha banshee?
1500cc of gear oil 75w or 80w
How much gear oil in a Yamaha banshee in ml?
1500ml
How much gear oil does a Yamaha virago 535 hold?
Yamaha Viraho 750 holds cca 2 dcl of gear oil. I think it will be about the same.
How much oil for 2002 Yamaha blaster?
About 1 quart of gear lube
How much gear oil does a 97 Yamaha yz 125 take?
It would take four quarts of gear oil.
How much horsepower does a stock 2003 Yamaha R1 Have?
152
How much gear oil do I put into a 2003 Yamaha yz125?
i think its 650 cc's. it also should say on the clutch covering by the oil cap. my manual says for an oil change is 21.98 oz.
How much horse power does a 2003 Yamaha viper have?
+/- 130 h.P.
How much coolant does your 2003 Yamaha banshee hold?
2 quarts
How much does it cost to fix second gear Yamaha 99?
it cost ten throe seventy dollars
How much horsepower does a stock 2003 Yamaha warrior 350 have?
89 gerbil power
