Control
1.73 is the square root of the whole number 3, (rounded off to two decimals), and is used in virtually all 3 phase calculations.
Yes, of course. A single-phase load is connected between any two lines of a three-phase, three-wire, system, or between any two lines or between any one line and the neutral of a three-phase, four-wire, system. It's important, of course, that the resulting voltage matches the requirements of the load.
They will not be very different.
Its is the condition when two different phases directly comes in contact with out any load or resistance.
a phase is a region with homogeneous (uniform) properties and a conversion between states is called a "phase transition"
Single-phase, 2.5 amps; three-phase 1.443 amps.
Control
There is no need of single phase to three phase conversions. Both service types are available from the local utility company.
The direct conversion of a solid to a gas is called sublimation. In this process, the solid phase skips the liquid phase and transforms directly into a gas when heated.
No. The phase is the phase, no matter your gaze.No, but it will appear to be oriented a different way depending on your location.
Because that is the simplest, cheapest and most efficient way to do it.
No. The phase is the phase, no matter your gaze.No, but it will appear to be oriented a different way depending on your location.
no loss of data since it is not introduced on the company as a whole but only a segment
They pilot a plane!
phase change
the dress of the pilots are different