I presume you are talking about how to change the direction of rotaion on an electric motor. To change the direction of a three phase motor, switch any two wires of the three phase feed, and the motor will rotate in the opposite direction.
Chat with our AI personalities
An anemometer consists of 3 or 4 cups attached to a rotating shaft by thin rods. When wind blows, the cups and the shaft rotate. The speed of the wind is read using a meter similar to a car's speedometer attached too the shaft.
magnetic flux will be induced its use to rotate the shaft or given some force
A footstep bearing is essentially a cast-iron block with a gunmetal bush that has a hollow collar fitted on its top. This bearing is used to keep the shaft upright in a vertical position. The shaft is fixed in place and not allowed to rotate by a pin.
turbo blower is an equipment where a turbine is attached with the blower part. steam enters through the turbine inlet and expands through the blades and goes to the outlet which helps the turbine shafts to rotate. this turbine shaft is attached with the shaft of blower that makes the blower rotating.
easy, mount two in frame, place layshaft in middle with bearings, and collars to secure. Imagine a shaft that runs at the side of one, with gear on end, then rotate image in your head, and place another motor in , and wire up in opposite rotational direction. rc model guys do it on small scale, google it. steve