answersLogoWhite

0


Best Answer

So you opened your mail, and got the water bill is much higher than it is supposed to be. You have called the water company hoping it was a mistake, but they said it is not. Perhaps they send someone out to make sure the meter is working properly, but it is. You have not seen any sign of water around your house. You have not wasted three times your normal water usage filling the pool over and over again or watering your lawn non-stop, so what is happening? Check the toilets and sinks in your house, and if you can't find another cause for the increase, you may have a water leak. If the water company comes out, they will look at your meter, and they may tell you that a leak indicator on the top of the meter may be spinning away. this is a classic indication of a water leak and often a slab leak. There are several different type of slab leaks. The service line of your home runs from the water meter to the shut-off valve in your house. If you close the shut off valve in your house, the leak indicator on top of the water meter will continue to spin. If you have a leak in your home between the shut-off valve and and of the water fixtures in your house, when you close the shut-off valve, the leak indicator will stop also. If the leak is on the service line, there is still a chance, even if you don't see water in your yard, that the leak on the line could be outside of your slab. This is most likely in climates where freezing is an issue as service lines are often required to be 36-48 inches under ground, and that depth can allow even significant water loss to dissipate before reaching the surface. In areas where freezing is not a concern, lines are often run much closer to the surface, and leaks on the service line outside of your slab are more readily apparent. Never fear!! Once you realize that you have a leak, you know what the problem is and can get started on the path to getting it fixed.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you determine a water leak in home?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Engineering

How do you detect if it is a slab leak?

First, you need to determine if you have a leak anywhere in your home. Check to make sure that your faucets, toilets, showers, hoses, ice-makers etc are not using water. Once you have determined that nothing visible is leaking, look at the water meter. The leak Indicator is a small triangle or star on the face of the meter, and if it is moving, even slowly, you have a leak somewhere. If you turn of the shut-off valve (often near the ground in a closet or near the hot water heater) to close it, and the leak indicator stops, then the leak is on a supply line to a fixture in your home. The shut-off valve often appears to go nowhere. It comes out of the wall, an perhaps splits off prior to going straight back into the wall or slab floor. If the leak indicator does not stop when you close the shut-off valve, the leak is on the service line into your home, and may or may not be under your slab, but is definitely under the ground. Movement on the leak indicator usually means a good deal of water is leaking, and you should see water coming from a wall or perhaps out of the floor. If you have no visible water, and constant movement on the indicator, a slab leak is a good bet. A leak detection company can help you find it, and get it repaired. More information us available at our blog for slab leak detection. It has more information on how to find slab leaks, what are slab leaks, and how to pay for slab leaks.


Why do water leak before coming to your house?

Because there is a leak in the pipe of the water main.


Why is water coming out from under the slab foundation?

you may have a septic system leak or a water main leak


How do you find a water leak?

Water leaks can be tricky. If water is visible on a wall then it could be necessary to cut into the wall to find a leak. Listening in a very quiet house may allow you to hear a spraying leak. If a leak is suspected because of a high water bill, look at the water meter. The small dial moves when water runs. Shut off cut offs under the sinks and toilets and the water should stop running. Turn them on one at a time and watch until the meter tons again. There is your leak.


How do you find a leak in an irrigation pipe?

By applying pressurised water at one end of the pipes. The water leak can be found out and it can be sealed by using adhesives.

Related questions

What are some ways of checking whether or not a house has a water leak?

There are many ways one could detect whether or not their home has a water leak. If one suspects a water leak in their home, they should check their water meter and also their water bill for unusual activity.


I have a waterline leak at my home from the street to my home .....can I get a grant to fix this leak?

I have a waterline leak at my home from the street to my home....can I get a grant to fix this leak?


How do you fix an antifreeze leak in a 97 Nissan Sentra?

Pressure test system to determine where leak orginates to determine fix


What are symptoms of a slab leak?

A high water bill or wet spots in the yard are often the first indications of a slab leak. You could even come home one day and find water coming up from under the slab floor of your home. This is clearly the most obvious symptom of a slab leak. Once you think you have a leak, you need to determine if you have a leak anywhere in your home this will not be as severe as a slab leak. Check to make sure that your faucets, toilets, showers, hoses, ice-makers etc are not using water. Once you have determined that nothing visible is leaking, look at the water meter. The leak Indicator is a small triangle or star on the face of the meter, and if it is moving, even slowly, you have a leak somewhere. If you turn of the shut-off valve (often near the ground in a closet or near the hot water heater) to close it, and the leak indicator stops, then the leak is on a supply line to a fixture in your home. The shut-off valve often appears to go nowhere. It comes out of the wall, an perhaps splits off prior to going straight back into the wall or slab floor. If the leak indicator does not stop when you close the shut-off valve, the leak is on the service line into your home, and may or may not be under your slab, but is definitely under the ground. Movement on the leak indicator usually means a good deal of water is leaking, and you should see water coming from a wall or perhaps out of the floor. If you have no visible water, and constant movement on the indicator, a slab leak is a good bet. A leak detection company can help you find it, and get it repaired. More information us available at our blog for slab leak detection. It has more information on how to find slab leaks, what are slab leaks, and how to pay for slab leaks.


How do you determine the source of a cabin water leak in a 1999 Volvo S80?

that is the heater core that is leaking which is located behind the radio.


Home insurance cover for gas pipe leak?

The only likely expense they would pay would be to tear out that part of the building to get to the gas leak to determine why it was leaking. 99.9% of the time, the repair is not covered.


How do you detect if it is a slab leak?

First, you need to determine if you have a leak anywhere in your home. Check to make sure that your faucets, toilets, showers, hoses, ice-makers etc are not using water. Once you have determined that nothing visible is leaking, look at the water meter. The leak Indicator is a small triangle or star on the face of the meter, and if it is moving, even slowly, you have a leak somewhere. If you turn of the shut-off valve (often near the ground in a closet or near the hot water heater) to close it, and the leak indicator stops, then the leak is on a supply line to a fixture in your home. The shut-off valve often appears to go nowhere. It comes out of the wall, an perhaps splits off prior to going straight back into the wall or slab floor. If the leak indicator does not stop when you close the shut-off valve, the leak is on the service line into your home, and may or may not be under your slab, but is definitely under the ground. Movement on the leak indicator usually means a good deal of water is leaking, and you should see water coming from a wall or perhaps out of the floor. If you have no visible water, and constant movement on the indicator, a slab leak is a good bet. A leak detection company can help you find it, and get it repaired. More information us available at our blog for slab leak detection. It has more information on how to find slab leaks, what are slab leaks, and how to pay for slab leaks.


How do you fix an oil leak on a 1994 Subaru Legacy in Southern Mexico or is it even possible?

Determine where oil leak is originating to determine repair procedure


How do you fix an antifreeze leak on passenger side of car?

You have to determine the source of the leak then decide on how to fix it.


How do you fix vacuum leak on 2000 dodge 1500 sport?

First you have to locate the source of the vacuum leak then you can determine what steps to take to stop the leak. Determine the source and re-post your question with more info.


The air suspension front goes down why?

You have a leak in the system. Spray a mixture of dish soap and water on and around all the parts to the air suspension system. Once you have found the source of the leak you can determine how to fix it.


How do you fix an intermittent antifreeze leak from the engine?

Have cooling system pressure tested to determine origination of leak