Start with a circle of radius equal to the height of a right cone that would be the extension of your frustum. Measure or calculate from the bottom of the frustum up the side and subtract that from the first radius. This remainder is a radius to form a smaller circle concentric with the first one. Now determine the length around the top and bottom of the frustum. This will correspond to a number of degrees within your circles. Draw this angle from the center to the edge of the outer circle. Now cut out the small circle and then the angle section. This should roll into the shape you want. If you use paper for this, be mindful of the grain of the paper. Poster board only rolls in one direction.
To calculate the counter weight just simply use this formula V3x (-)> 3.16 + belt radius = weight it took me 14 days to come up with this theory use it wisely Please and thank you.
we can weight one sheet and calculate the unit weight we can weight one sheet and calculate the unit weight
Subtract the estimated weight of fuel and passangers from the vehicle's rating.
If a swing has a working load of 300 pounds and the rotation hook has a working load of 1000 pounds, what is the maximum weight of a person that would be allowed on the swing?
i have an answer for both a frustum of a pyramid and a frustum of a cone which do you need frustum of a cone just give both of them
Most likely, a frustum of a sphere.Most likely, a frustum of a sphere.Most likely, a frustum of a sphere.Most likely, a frustum of a sphere.
There is no frustum of a cone. There is a frustum, which is a cone with the top cut off parallel to the ground.
Since a frustum is a portion of a solid, three-dimensional figure, and a rectangle is a plane, two-dimensional figure, there can be no such thing as the frustum of a rectangle.
Calculus was invented or rather can be detailed as back as 1820 B.C. when the Egyptians used it in order to calculate the volume of the pyramidal frustum
A frustum. Specifically, a frustum of a triangular pyramid -- as one could also have a frustum of a cone, square pyramid, etc.
Yes and it is cone that has part of its top cut off parallel to its base and it looks like a plant pot.
A large cone has a greater volume than a small frustum while a small cone has a smaller volume than a large frustum
Yes, it must because a frustum is only a part of a cone.
A frustum. Specifically, a frustum of a triangular pyramid -- as one could also have a frustum of a cone, square pyramid, etc.Read more: What_do_you_call_a_triangular_pyramid_with_the_top_cut_off
A frustum of a square pyramid is like a slightly distorted cuboid. It has 12 edges.
xyz2