It does things to the things in the things the pipes are made out of if you get me
Place a bucket beneath the 'U' bend to catch any water, and undo the pipe joints to remove the 'U' bend. Clean the pipes and 'U' bend as much as possible, before replacing the 'U' bend and tightening the joints (usually by hand if the pipes are plastic).
As water drains, it displaces air in the pipes. If the vent or vents in your house are clogged up, the air must find another way out, which could be another drain in your house.
No, not necessarily. Most likely the drain has become rotten because of something acidic going into it. Vent pipes usually have a good flow of air in both directions. I would just change the bad waste pipe(s).
To take up the thermal stresses which build up as when a metal is heated it expands and when it cools it contracts. If the pipe is straight without a bend the thermal stress will cause it to buckle, it will develop a kink, or may even crack - defeating its very purpose so the bends
It depends on the developed length and fixture units.
It does things to the things in the things the pipes are made out of if you get me
With a paintbrush.
Place a bucket beneath the 'U' bend to catch any water, and undo the pipe joints to remove the 'U' bend. Clean the pipes and 'U' bend as much as possible, before replacing the 'U' bend and tightening the joints (usually by hand if the pipes are plastic).
Where it is not possible to bend a pipe due to lack of equipments or the thickness of the pipe, the miter bend is made by cutting the pipes at desired angles.
There are vent pipes throughout every building. If you feel they are not adequate you can add an AAV or two to help.
Place a bucket beneath the 'U' bend to catch any water, and undo the pipe joints to remove the 'U' bend. Clean the pipes and 'U' bend as much as possible, before replacing the 'U' bend and tightening the joints (usually by hand if the pipes are plastic).
You should not , it is only a vent
Piping is installing pipes such as waste /vent/ soil / gas/ water/ etc.
The reed pipes used by a satyr can bend the forces of nature thus making it able to disarm there opponents
Waste - Vent - water supplyMaterialsCopper - Cast Iron - plastics
It is possible on larger dia pipes but on smaller ones replacement is the ticket.