The flip-flop can be configured to change state on each clock pulse. This causes the output of the flip-flop to be one half of the input frequency - hence the term "frequency division".
You can also configure more than one flip-flop into other divider scenarios, such as divide by 3, 5, 10, etc. You can also use the output as the input to a phase-locked-loop, resulting in frequency multiplication.
both flip-flop and buffers are used for same purpose(i.e) for holding the data for a specified clock period.....in the case of area reduction these buffers can be used in the place of flip-flop.....
Binary is NOT called a flip flop!binary is a mathematical notation for writing numeric values with only 2 symbolsa flip flop is one type of electronic circuit having 2 stable statesThe 2 stable states of a flip flop can be used as one way of physically representing and storing the 2 symbols of binary notation, but there are millions of other circuits and mechanisms that can do the same!
no indeterminate state
Frequency-division multiplexing, wavelength-division multiplexing, and time-division multiplexing.
to make a anoying noise when you walkAns.2 The noise comes from a type of shoes called flipflops - no hyphen.Flip-flops have a variety of uses; the two common ones areTo act as a 1-bit read write memory, often called a flagTo divide a series of level transitions (or pulses). One flop will divide by 2. Two flops cascaded will divide by 4. A block of cascaded flops which are wired to reset to zero when a particular state is reached will divide by any desired number.ANSWER: FLIP-FLOP are THERE to create logical functions in machine language like storing, counting, shifting.
A flip-flop is used to store state information.When a low is applied to the CLR input the flip-flop will be cleared.If a low is applied to the PR input, the flip-flop will be preset.
Flip flop in circuit That has two states. fili flop can be used to store the states information .
The application is simple a flip for every input change
both flip-flop and buffers are used for same purpose(i.e) for holding the data for a specified clock period.....in the case of area reduction these buffers can be used in the place of flip-flop.....
One can purchase new flip flop slippers from Zappos, dearfoams, Target, Overstock, Amazon, Tempur-Pedic, Macy's and both used and new flip flop slippers from eBay.
flip -flop are nothing ,just latches, are used to store 1 bit values. suppose an 8 bit register can store 8 bits(1 byte) i.e. it comprizes of 8 latches/flip flop each bit corresponding to 1 flip flop
flip flop
A flip-flop is an electronic circuit that has two stable states. Flip-flops have many uses. In computers, a flip-flop could be used in memory, where each flip-flop holds one bit of information; or in the CPU, where flip-flops are parts of circuits that perform logical and arithmetical operations.
In a master-slave flip-flip arrangement, the master flip-flop determines its state on one clock edge, while the slave flip-flop determines its state on the following clock edge. This way, the end-to-end output does not ever change on any one clock edge, so no race condition is possible.
Flip flop in circuit That has two states. fili flop can be used to store the states information .
A: Basically is to synchronize date with a clock
to determine the output state of the flipflop