to stop condesation of water from the surface of pipe.
It makes noise because it's sucking the water back in to stop letting the water escape.
Depending where the noise is coming from but normally this type of question relates to water hammer which is caused by pipes not being secured properly, make sure all piping on walls and in roof are secured down properly with pipe straps, pipe clips or pipe holders.
A curb stop is the valve which the city or municipality has installed to turn the water service off and on to a building . Some private systems also have curb stops installed if there are multiple buildings on a common well or water service a curb stop box refers to the enclosure which houses the actual valve most curb stop boxes are not boxes at all but cast iron housings with a pipe that extends to the ground level with a removable cover the valve is accessed with a special wrench which is slid down the pipe and turns the valve off and on.
Turn off at curb stop to decommission whole house or building. Inside of house or building, turn off valve at main water supply at meter and cut and cap cold water line to be decommissioned.
Ex: Try as she might, Ms. Stevenson couldn't stop her husband from fixing the leaky pipe by himself. He had unshakableconfidence he could do it..
Repair the pipe of fixture to stop your leak.
Yes, and I use kid's modeling clay. It works and I keep a block of it around the house to fix things like this.
Repairing the section of pipe that is leaking will stop a leak on a hot water line.
Someone may have shut off the water to that faucet, or a pipe may have froze, or there may be air in the pipe.
It's a valve that regulates the main water pipe.
Yes and no but they will also stop water from running through the pipe all together if left unchecked and also destroy the pipe.
to stop condesation of water from the surface of pipe.
If it is water you have a plugged condensation drain line that needs to be cleaned out. If it is engine coolant you have a leaky heater core that needs to be replaced.
If you suffer a burst water pipe, you would use the stop cock to shut off the water until you can have the burst pipe repaired. The stop cock is simply a valve that you can manually turn on or off. The main stop cock is usually near were the water pipes enter the house from outside - mine is in my kitchen. There may be a stop cock on the header tank in the loft, or on the inlet pipe to the hot water tank, or in some other places, such as below the bathroom sink, and so on. When things go wrong with your water supply inside your home, you can't have too many water stop cocks!
A spigot is a name for the pipe where water comes out of the plumbing. There is usually a handle that when turned can stop or start the flow of the water.
You can put a ball of white bread inside of the pipe it will stop the water longe enough to solder the joint then it will deteriate and come out of the pipe if you have an aerator on the faucet check it to make sure that the bread does net clogg the screen