0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How long does it take to build a peaking power plant in the US?
Time It takes To Build Peaking Power PlantIt typically takes one to three years to build a gas turbine power plant depending on the size and complexity. A 100 MW conventional gas turbine may take about a year. A 300 MW combined cycle power plant may take about two to three years. These estimates may increase if demand for gas turbines is high.
What is the positive of nuclear power plant?
what is negative of the nuclear power plant
Which power plant has least running production cost?
nuclear power plant
Why the nuclear power plant build?
Because the power plant is the source of electricity
When was the first power plant built and where?
The first power plant was built in Bavarian in 1878
Does combined cycle power plant has a boiler?
No It has heat recovery steam generator
What is the efficiency of thermal power plant?
A modern combined cycle gas turbine/ steam turbine power plant can reach almost 60% efficiency.
How do you calculate the plant load factor of hydro electric power plant?
PLF of Hydal Plant - 100% or 101%
Should a power plant where the prime mover is a gas turbine be categorized as a thermal power plant?
No, a power plant that uses fossil fuels such as gas or coal, cannot be classified as a thermal power plant. A thermal power plant uses the heat from deep within the earth, combined with water to create steam, which then powers the turbines.
What are reasons for over speed tripping of steam turbine genarator in a combined cycle power plant?
wHAT??
Heat Rate in Natural gas based Combined Cycle Power Plant?
today rate of natural gas
How do you calculate heat rate in gas power plant?
E=MC2 + o2 + H20 = Heat rate
Where is India's first 140 MW integrated solar combined cycle power plant is planned?
Mathania, near Jodhpur, Rajasthan.
What is commissioning in a power plant?
Commissioning can be of any machinery, unit, or plant. So the commissioning of a power plant or steel plant is somewhat similar.Commissioning denotes the trials of the component individually, machines, and it's part individually and as a whole and later on, all combined together( commissioning of the unit). After the commissioning of each unit, the plant as a whole is commissioned.
This 140-mw iscc integrated solar combined cycle power plant with a solar thermal power generation technology will be indias first and among the worlds largest?
madhya pradesh
Operation of a combined cycle power plant?
A combined cycle power plant has multiple thermodynamic cycles. This increases efficiency. For example, a gas turbine can be used to produce electricity, but only about 40% of the heat is actually converted in the process. 60% of the heat is lost, and in a single cycle plant would be considered waste heat. In a combined cycle plant, that waste heat could be used to drive a second, steam turbine to produce more electricity. In such a case, the efficiency could be increased from 40% to nearly 60%. It is possible to go further. The waste heat from the combined cycle electric plant can be used to heat buildings, for instance, increasing overall efficiency to more than 65%. This is called Cogeneration.
Which is the main fuel is used in Kayamkulam Thermal power station?
The main fuel used in the Kayamkulam Thermal Power Station is natural gas. It is a combined-cycle power plant that primarily relies on natural gas to generate electricity efficiently and with lower emissions compared to other fossil fuels.
