The term bootstrap comes from the process of initializing the circuit or computer from a power off-on transition. The term is akin to picking one's self up by one's boot straps.In an ordinary logic circuit, this entails making sure that the circuit starts off in the right state following power on, usually by having a resistor charge a capacitor from VCC, forming a RESET signal. Often, there is a diode across that resistor, so that short power off-on sequences force a reset.Taking this further, into the computer, the RESET signal causes the processor to execute a bootstrap program out of ROM that initializes everything and loads the rest of the program from disk. (Some imbedded controllers do not have disks, but the principle is the same.)
No. I don't need one. Nor is it possible on WikiAnswers.
A closed circuit works by having electricity flow in a complete circuit or circle or any closed shape.
i dont know this answar
VLSI
A bootstrap sweep circuit is a connection between two machines that can be used by themselves. It would be like linking a computer to a printer without Internet capabilities. The printer can work without the Internet on its own and so can the computer.
circuit paul ricard
Bootstrap in an EMC network is a type of automatically saved data set containing information for resources and media. It works as a form of disaster recovery.
That depends what circuit it is in. If it is in a sweep circuit (vertical/horizontal) no because it will change the frequency of the circuit. If it is in a power supply circuit, probably yes becuase it is probable only being used as a filter. BUT if that leg of the power circuit supplies a sweep circuit, no.
The term bootstrap comes from the process of initializing the circuit or computer from a power off-on transition. The term is akin to picking one's self up by one's boot straps.In an ordinary logic circuit, this entails making sure that the circuit starts off in the right state following power on, usually by having a resistor charge a capacitor from VCC, forming a RESET signal. Often, there is a diode across that resistor, so that short power off-on sequences force a reset.Taking this further, into the computer, the RESET signal causes the processor to execute a bootstrap program out of ROM that initializes everything and loads the rest of the program from disk. (Some imbedded controllers do not have disks, but the principle is the same.)
Kyalami circuit in south Africa Kyalami circuit in south Africa
Bootstrapping is used to allow bias to be applied to the base of a transistor while maintaining a very high input impedance.
Bootstrap Productions was created in 1999.
A sweep generator is an instrument used to align IF circuits in older FM radios that used adjustable IF coils in the circuits. The generator "sweeps" the frequencies on either side of a set center frequency. When this signal is applied to the front end of an IF circuit, the responce from the IF circuit can be observed at the end of the IF with an oscilloscope allowing the IF coils in the circuit to be adjusted to the desired bandwidth and responce of the circuit.
You know your circuit works when it does what you designed it to do, and prefferably as little else as possible.
No. I don't need one. Nor is it possible on WikiAnswers.
Fred McGuinness has written: 'The wheat city' -- subject(s): Pictorial works, History 'Bootstrap four'