One way to determine current is to measure it, with an ammeter. Another way is to calculate it using Ohm's law: current = voltage / resistance.
Pressure from the voltage.
That will depend on the internal resistance of the battery. I = E / R Where I is the current, E is the open circuit battery voltage, and R is the internal resistance of the battery.
Yes. Pressure being voltage. Voltage divided by resistance equals current.
Yes In parallel circuit , current entering into the circuit will be divided intodifferent paths ( resistances) . Amount of current flow depends upon the magnitude of resistance applied in the circuit. Total current after passing through the circuit will be the sum of all current through each resistance.
To by pass the extra current from the limit of Galvano meter & this parallel resistance value depend upon the by passed current.
One way to determine current is to measure it, with an ammeter. Another way is to calculate it using Ohm's law: current = voltage / resistance.
Pressure from the voltage.
current depends on applied voltage and resistance.
Electronics resistor are a basic passive element it oppose the flow of current . the opposition depend upon the value of that resistance high value resistance will only able to flow some few amount of current through them. but low value of resistance allow to flow large current through them.
A: The EMF and total resistance
No. Resistance does.
voltage
No. Current and voltage are directly proportional to one-another and both are related to resistance by Ohm's law: V = IR or Volts = Current * Resistance So the current will depend upon the voltage and the circuit resistance by rearranging the above equations: I = V/R Meaning that the current will decrease as circuit resistance is increased if the voltage remains constant.
voltage depend on current and resistance r.p.m depend on no of pole
In general, yes, it does. For example, if you move a conductor in a magnetic field, this will induce a certain voltage between the extremes of the conductor; the corresponding current will then depend on the resistance.
yes