For some kinds of electric motors - not all kinds - the answer is yes.
It is hard to explain the reasons using very simple terms, but here goes:
Most small direct current electric motors that have stators which are made of permanent magnets can be made to generate direct current electricity when their rotors are turned at a fast enough speed by another engine, such as, for example, a car engine or a steam engine.
For more information see the answer to the Related Question shown below.
If the motor is connected to an ungrounded delta supply service there will be no effect on the operation of the motor. If the motor is connected to a wye system supply service and the B phase grounds out, the motor's overload protection would take the motor off line from the electrical supply.
of course you can.but the purpose of electricity is lost here.generators run by petrol or diesel engines are used because you dont have a electric supply or there is a power outage.if there is no power how can you run the electric motor which runs the generator.hence the generator is always coupled with and diesel IC engine.
As the motor is a three phase machine,it must be AC supply
That happens when the supply is turned off, and the motor runs down and stops.
With no three phase power supply you can't use a three phase motor of any kind at all!
Trains are built with plastic and metal. Electricity is used to run the motor in the train. The train gets the electricity from the track or catenary wire which is connected to the appropriate power supply.
no and never in 2015, ghana will supply nigeria with electricity
Electricity Supply Commission of Malawi was created in 1998.
To supply electricity in the event that the main power supply is unavailable and electricity is needed, or when it is impossible to connect everything that needs electricity to an outlet.
Electricity Supply Industry Planning Council ended in 2009.
Electricity Supply Industry Planning Council was created in 1999.
just connect the supply of motor to power supply..and run..then ovserve the motor sounds,temperature and vibration.
Magnet->Electricity->Motor
The the supply stays within +/- 5% of what the motor is rated for, you can do this.
Electricity for industries are supplied with high voltage.Domestic supply is with low voltage.
electricity is formed into motion by a motor
A fan can use both voltages depending on what the manufacturer nameplates the motor voltage to be. AC is the most common voltage but some smaller fans like power supply fans in computers use a DC voltage. Check the fan motor's nameplate to supply the correct voltage.