Every switch performs a control function. On / Off is a control function.
To control a light with a switch, the switch has to be connected in series with the light fixture.
The relay's coil(s) would be a load, but the main function of a relay is to act as a switch to control power to a larger load.
A relay will have a control circuit and a function circuitcould be the same feed line. One set of terminals (Hot and Load) can be activated at all times, but will not function until the control circuit is closed. The control circuit has a Hot and a Ground--when activated either by supply hot or ground by switch. The internal coil closes allowing the function circuit to operate. The purpose of this relay is to reduce the spike to the alternator. It takes less current (voltage) to close the coil on the relay than it would to operate the accessory that it controls
A switch is a make - break device. Its function is a circuit is to make and break the current flow of the circuit that it is in. This action then starts and stops the load that is connected in the circuit.
what is the function of data switchesof digital training system
A TBS switch is an air switch that has only one control function. They control the functions of electronic devices from locations that are not near the device.
the thermostatic switch of the control of the compressor and control of colld of the system
A browser performs the function of connecting or linking you to the global web.
It's on the wiper control switch on the multi-function switch.
"Multi-function switch" usually refers to the turn signal/wiper control module which is located on the steering column at the base of the signal/wiper control lever.
Its function is to get dat, process it and forward the results to output devices. It performs it with the help of ALU and Control Unit.
Mitosis performs a similar function in people.
I am assuming the "multi-function" switch is the TURN SIGNAL/HI-LO BEAM/WIPER CONTROL SWITCH. It is located on the left side of the steering column.
You can control both the fan and light with a single dimmer switch by using a dual-function dimmer switch that is specifically designed for this purpose. This type of switch allows you to adjust the brightness of the light and the speed of the fan independently using the same control.
A 4-wire light switch has an additional wire for controlling a separate function, like a fan or dimmer, while a standard light switch only has 3 wires for on/off control.
Aggregate Function
the Golgi function the same as the nucleolus