Simply multiply the peak voltage to 2 and you will get the peak to peak voltage.
The maximum DC voltage you could expect to obtain from a transformer with an 18V rms secondary using a bridge rectifier circuit with a filter capacitor is about 24V.This assumes a truly sinusoidal AC waveform, and a forward conductioin voltage of 0.7 volts across each diode.Multiply 18 by the square root of two, and subtract two times the diode voltage.The maximum is the peak value. If there is any load on the output, there will be some ripple, but the peak value will still be around 24V.To calculate the output voltage of single phase diode bridge it is reasonable to assume a filter capacitor exists across the output and realize that it will be charged to the maximum voltage available to it.
You are confusing terms. Current is measured in amps or some fraction thereof. If you have a 24 volt battery (All batteries are DC) you need to connect a load to the battery and then measure the current that flows in the circuit. The current is measured in amps, milliamps or perhaps microamps for a very high resistance load.
This kit includes an 18V 2 speed drill/driver, 18V 7-1/4" circular saw, 18V reciprocating saw, 18V cordless flashlight, 2-18V batteries,and a charger.
The question doesn't make sense. 18V is a measure of potential difference while horsepower is a measure of power. If you find out the current, then you can calculate the power and compare the two quantities. Power (in watts) = Voltage (in volts) * Current (in amps) and 1 hp = 746 Watts so 18V * current (in amps) / 746 = power in horsepower. (this assumes the 18V is DC)
Sources with different voltages should never be connected in parallel, you would have a difference of potential. Any time you have a difference of potential connected together you will have sparks, which could cause the batteries to explode.
V=R I then, V = 10 + 8 = 18V, R=2Ohm, I=V/R=18/2=9A
6 and 18v, respectively.
How do I change the blade on my 18v Ryobi cordless circular chain saw?
To convert VA to amps for DC, you can use the formula: Amps = VA / Volts. For the given values, the max DC current would be 35VA / 20V = 1.75A. The 18V AC value cannot be directly converted to amps without additional information.
No.
Batteryship is one website where you can buy a box of Makita 18v battery's refurbished.
Simply multiply the peak voltage to 2 and you will get the peak to peak voltage.
Batteryship is one website where you can buy a box of Makita 18v battery's refurbished.