0
Add your answer:
Earn +20 pts
What is the difference between voltage forward voltage and voltage drop?
Voltage is the potential difference between the source & any point in the circuit. The forward voltage is the voltage drop across the diode if the voltage at the anode is more positive than the voltage at the cathode (if you connect + to the anode). Voltage drop means, amount of voltage by which voltage across load resistor is less then the source voltage.
What is voltage gain?
Voltage gain is the ratio of the output voltage of an amplifier to its input voltage.
What is voltage amplitude?
Voltage amplitude is the maximum value of a voltage.
What is knee voltage and breakdown voltage?
Knee voltage (cut in voltage) :-The forward voltage at which the current through the P-N Junction starts increasing rapidly is called as Cut in voltage or knee voltage Breakdown voltage :-It is the minimum reverse voltage at which the P-N Junction can conduct without damage to the current
What is the voltage in your area?
the energy in the area is called ME-Kos.
How is voltage measures use of load measured in a circuit?
a little thing called an ammeter, you clip this onto your circuit and it measures the voltage!xxx ask again
What the relationship between clipping level and dc voltage?
This of course depents on the amp you are using. Generally increasing the dc-voltage will decrease the input signal strength at which it will clip, but of course only if your amp is build to be able to handle a higher dc-voltage.
1. What is the relation between the clipping level and DC voltage applied?
This of course depents on the amp you are using. Generally increasing the dc-voltage will decrease the input signal strength at which it will clip, but of course only if your amp is build to be able to handle a higher dc-voltage.
How do you use an antistatic wrist band?
There is a strap which you wrap around your wrist and a wire with a clip on the end. Attach the clip to the chassis of the computer to eliminate static electric discharge. Any difference in voltage between the chassis and you will flow through the wire and be neutralized.
Can you use a capacitor instead of zener diode in biased clipping circuit?
No. The purpose of the zener diode is to clip (turn on) at a certain voltage. A capacitor will not exhibit this behavior.
What happens to the clipping level when you freeze a diode?
Clipping level increases. For example, if the clipping level was 2V before freezing, it will clip at a voltage greater than 2V when frozen.
How to Disable a 1992 corolla alarm?
Find the wire that is feeding it voltage and clip it.
What is a clipper in electronics?
a clipper, in electronics, is a circuit which cut-off or "clips-off" a portion of a given input waveform...clippers can be easily realized using diodes and resistive elements... the design of clippers is essentially based on circuit analysis and understanding of working of diodes.it is that circuit which clip off the input voltage without affecting other part of the inputit is that circuit which clip off the input voltage without affecting other part of the input
What part of speech is the word clip?
Clip is a noun (a clip) and a verb (to clip).
What does code p10102 maf or vaf a low input mean?
It means you have low voltage to the sensor. Before you replace it, get a simple multimeter, check the voltage on the clip for wire, you can google which wires to test and how, then upstream on the same wire, i had the same issue. It turns out the maf was fine, the wire clip that attaches to the sensor was bad. It caused the car to rev in idle and the transmission would hit hard when going from park to drive. All this was cured with a $ 40 replacement wiring clip. Check wiring first, i had all kinds of advice from low cost such as throttle position sensor, IAC valve and MAF replacement.
What are some good horse cliping patterns?
Hunter Clip Bib Clip Trace Clip Blanket Clip
How do you use a stage clip?
whats a stage clip. is it a clip that you stick on stages lol
