A transformer substation comprises of transformation equipment- the transformers, the accessories for the connection of the transformers to the HT Lines (Primary Input)- usually concrete poles/steel towers, insulators etc; normally two or more transformers are present to allow maintenance and faults without the supply being interrupted. 2. The substation protective equipment such as lightning Arresters, Line Fuses and Breakers, Isolators (as appropriate) 3. Effective Earthing system and equipment 4. The Distribution equipment such as feeder pillar units, busbars etc depending on the type of transformer substation.
a substation go to http://www.chacha.com/question/what-are-small-buildings-containing-Transformers-and-electrical-equipment is where i found the anser
the pocket substation have three major parts and they are transformer , ring main unit (RMU) and low voltage distribution bored (LVDB).
A substation that is smaller than the average substation. A substation converts electric power from one voltage to another.
The Substation which comes power from the power plant know as pooling substation.
The mesh size in the earthing design for substation can be various size depend on the area. For area that does not contain equipment, we could increase the mesh size because there is no equipment to cause touch potential. But if the area is at the corner of the substation, the mesh size should be smaller because to limit the step potential.
A transformer substation comprises of transformation equipment- the transformers, the accessories for the connection of the transformers to the HT Lines (Primary Input)- usually concrete poles/steel towers, insulators etc; normally two or more transformers are present to allow maintenance and faults without the supply being interrupted. 2. The substation protective equipment such as lightning Arresters, Line Fuses and Breakers, Isolators (as appropriate) 3. Effective Earthing system and equipment 4. The Distribution equipment such as feeder pillar units, busbars etc depending on the type of transformer substation.
a substation go to http://www.chacha.com/question/what-are-small-buildings-containing-Transformers-and-electrical-equipment is where i found the anser
the pocket substation have three major parts and they are transformer , ring main unit (RMU) and low voltage distribution bored (LVDB).
Microwaves in substations are primarily used for communication purposes, providing reliable and high-speed data transmission between different equipment within the substation or to a supervisory control center. They can also be used for protection and control signaling, enabling efficient operation and monitoring of the substation equipment.
A arrangement of Equipment between two bus-bars. Example 1 and 1/3, 1 and half etc.
A substation that is smaller than the average substation. A substation converts electric power from one voltage to another.
132kV substation is part of transmission and distribution of power in which the transmission voltage is 132kV. The substation is for stepping down or stepping up of the voltages to the required voltage. the substation also serves as a place where the transmission lines can be isolated, controlled and monitored. The substation consists of different equipment that is used to regulate, monitor and distribute the required power.Another AnswerIn the UK, 132 kV voltages are considered to be the lowest transmission voltages. Other transmission voltages are 275 kV and 400 kV. A '132-kV substation' is normally one in which this voltage is stepped down to a primary distribution voltage, usually 33 kV but, sometimes, 66 kV. As the previous answer points out, substations contain transformers, switchgear, busbars, and protection equipment.
The Substation which comes power from the power plant know as pooling substation.
basically there will not be any difference between them. the capacity of equipment will be more such as the CB rating will be more basically there will not be any difference between them. the capacity of equipment will be more such as the CB rating will be more
In a substation there are many items. Circuit Breakers Disconnectors Earth Switches Current Transformers Voltage Transformers Surge Arrestors Power Transformers Insulators
Jefferson Substation was created in 1909.