Spur
Definition from the National Electrical Code Article 100:Feeder. All circuit conductors between the service equipment, the source of a separately derived system, or other power supply and the final branch-circuit overcurrent device.Branch Circuit. The circuit conductors between the final overcurrent device protecting the circuit and the outlet(s).
A final subcircuit is the circuit which the number of points supplied do not exceed 15A
Inductors tend to oppose a change in current, so the initial current is low, and rises according to the RC time constant of the circuit to a final value.
You can wire the refrigerator on a dedicated 15 amp circuit using AWG #14 wire but, know that as of 2014 the refrigerator must be on a GFCI protected circuit that is readily accessible. As you will normally mount the outlet behind the refrigerator you would have to move the unit to reset the breaker if and when it tripped. I would wire the refrigerator on one of the 20 amp kitchen counter-top circuits that is GFCI protected. Now, my answer may be debatable but from how I read the NEC code you can wire it to one of the kitchen branch circuits as long as the refrigerator does not pull more than 16 amps. You might want to check with your local inspector to get his opinion as he is the one who will have the final say.
It as simple as the name implies ring circuit ,it 's in the circular form that is from the panel to the outlet and back to the panel . While radial is from the panel and stop at the out let without going back to the panel.But note that in a ring circuit you must use 6mm cable and 32/30 amp fuse rated.AnswerRing-main circuits must be wired using 2.5-mm2 cables, not 6-mm (whatever that is) cables.
spur
Feeder because the trolley will have overcurrent protection. Branch circuit is the final OCD to the load.
The conductors between the service equipment and the final branch circuit include service conductors, feeder conductors, and branch circuit conductors. Service conductors connect the utility service to the service equipment. Feeder conductors distribute power from the service equipment to the panelboard or distribution board. Branch circuit conductors then carry power from the panelboard to individual outlets, fixtures, and appliances.
Definition from the National Electrical Code Article 100:Feeder. All circuit conductors between the service equipment, the source of a separately derived system, or other power supply and the final branch-circuit overcurrent device.Branch Circuit. The circuit conductors between the final overcurrent device protecting the circuit and the outlet(s).
A final subcircuit is the circuit which the number of points supplied do not exceed 15A
A final subcircuit is the circuit which the number of points supplied do not exceed 15A
Judicial branch
Judicial branch
Mainly, the executive branch is to enforce the laws established by the legislative branch, while the judicial branch has the final say on interpreting the law.
They were the final judge in all laws.
Armageddon is what is described as the final battle between good and evil
The Judicial Branch has the final say on all laws. If a law is brought to them, they decide if it is constitutional or not.