1. remove the interior from door ( you will need to pop window controls out and unplug ) 2. you will see 3 bolts ( Hex head ) remove them , unplug electric wires and remove . 3. reverse to install
To remove the rear window regulator on a 1994 town car, remove the screws under the arm rest. Take off the rubber insulation and unplug the speaker wires to get it our of the way. Finally, remove the window regulator.Ê
It depends whether or not your trailblazer came with heated seats, but if it did the switch would be on the door. The door switches should be (from front to back) Window Lock, Forward Window Controls, Passenger Window Controls, Door Lock, Seat Heaters.
Remove window handle(pin removal tool 5.95 advance auto), take screw out of door handle, take 3 screws off speaker cover, remove 3 screws holding speaker in, unplug speaker, pop 4 plastic snaps loose from bottom of door panel by sliding a screwdriver between panel and door. Then slide panel upward and lift it off.
fuse
you will take the rear door panel off..there should be one screw and some plasic 'trees'...you will slide the arm rest/power window switch through the opening (so you dont have to unplug it) and the 5x7/6x8 speaker will be right there...you will need a smalled socket set to remove the speaker
To install a new window regulator on a MGRZ driver's door, remove the door panel and the wiring attached to the power window mechanism. Remove stereo speaker from the inside door and the window glass. Remove the old window regulator and replace with new.
# Remove the door trim panel # Remove the mounting screws withdraw the speaker unplug the electrical connector and remove the speaker
First open the window and pry off the cover to the small speaker (opposite the mirror). Next pry off the small arm rest panel and the panel where the power window/lock controls are (unplug the windows/lock harnesses). Underneath you will find two Phillips screws (remove). Start near the small speaker and work your way down and around prying the panel off the door. Once you get near the top on the outer edge you can see a different colored snap inside. To get it off you must slide the panel right or left (depending on which door your doing). Then lift the panel up off the edge where the window goes up. Be sure to keep an eye on the door handle. Jesus loves you! God bless!
Yeah, quite easy remove window & replace with care...
There are Allen screws around the door panel. Sides and bottom. Remove those and the handle has a cover. separate the cover from the handle and remove screws. If there is a speaker in the door you need to find the little slots on the cover. Use a small screwdriver and pry the cover off.Remove the screws from the speaker. Pull out and up on the panel to remove. It has to go over the door lock and once it comes away unplug the light on the bottom of the door.
All you have to do is if its a power window truck is take the screws out of the door panel and pop all the clips loose. Then unplug the window and lock switches. There are 3 bolts that hold the mirror on behind door panel. If manual locks and windows, mainly the same but dont have to unplug wires but have to pop clip off handle for window and lock.