First, pop up the bonnet using the pull-lever to the right of the steering column inside the car. Now, having opened & secured the bonnet - For radiator coolant, the reservoir is an off-white container with a screw-top to the upper right as you face the engine. Unscrew the lid, pour water (or water/antifreeze solution) in up to the 'max level' indicator and replace the lid. For windscreen washers, the reservoir is an off-white vertical tube at the lower left, nearest the driver's side headlamp, with a light blue pop-cap. Simply pop the cap off, add water until full, and replace cap.
land rover discovery
Where do i top up my coolant on a rover 25
Yes it can!
no. use deionised or distilled water
The Land Rover systems are self bleeding, just fill the header tank with water, then run the car while topping the tank up as the car pumps the water around the engine. Then go for a drive and ensure the heater is hot and check the water level when you return. If you have a re-occurring problem of air in your water system it would not be uncommon to have a blown head gasket or a cracked engine block.
Through the oil filler cap on top of the engine
There has never been a land rover or any other type of vehicle on top of Mount Everest. Edit: They landed a helicopter on it twice in 2005 and a land rover was taken up Mount Erebus.
I come up with a 2017 Land Rover Discovery Sport.
Do not use condenser water in a car battery it is full of particles which will damage your battery.Buy proper top up water from an automotive shop.
There are hose repair kits available, but you are much better off by replacing the hose. Don't forget to top up with antifreeze after replacement. The Rover may need bleeding afterwards, the bleed screw (8mm) is located on the water rail going over the gearbox. attached to the engine block
Distilled water is water that has had all impurities removed. The impurities it regular tap water can shorten the life of a battery.
Check the overflow tank. Top up to indicated mark if necessary. When cool, remove radiator cap and top up rad with cleen water or coolant.