How do you reset an active headrest in a Hyundai genesis?

Answer 1

Note that the headrest need not be replaced in the event of deployment - merely reset.

TSB

09-80-001

1.

Remove headrest from seat and observe status of trigger lock. The trigger lock can be seen

within the deployed headrest.

If the trigger lock is unlocked, proceed directly to Step 3.

If the trigger lock is locked, proceed to Step 2.

2.

Apply 12 Volts DC to the pin at A, while grounding the sliding shaft. At the same time push the

trigger lock by hand into the unlocked position. Disconnect power. The trigger lock will remain in

the unlocked position.

3.

Turn over headrest and lay down on a

clean, flat surface

4.

Push the crash handle into the cover

using fingers

5.

Push cover

6.

Push cover until there is no gap.