the oil pressure switch is located on the back of the engine block closest to the alternator. it has a single Tan wire running to it, and a Grey connector.
No, there is no inertia switch on any Saturn.
After I switch gears in my 98 Saturn SC2 the gear 'slips'. Why?
On the motor!!
The low side port is at the end of the suction hose on the aluminum located where the end bolts up.......
It is connected to the washer tank.
The fuel pump is located in the fuel tank.
In the first generation SC2 the horn is located in front of the radiator.
I just changed the relay on my 99 sc2. It is a standard shift and i found the relay by following the wires from the cluch pedal safety switch. But basically on the 99 it is up under the dash on the drivers side taped to the wire harness. It was covered in black electrical tape.
how to use bcm to reset change oil light
It is on the back of the engine between the starter and alternator It has one wire going to it. Threads into the block with a nig "housing" on it Careful the oil pressure switch is right beside it.
The blower resistor is under the dash pad on the top of the heater box