Dissolved Oxygen (DO) is really a physical distribution of oxygen molecules in water. There are two main sources of DO in water: atmosphere and photosynthesis. Waves and tumbling water mix air into water where oxygen readily dissolves until saturation occurs. Oxygen is also produced by aquatic plants and algae as a by-product of photosynthesis.
The electrochemical method of measuring DO requires a cathode, anode, electrolyte solution and a gas permeable membrane. The material of the membrane is specially selected to permit oxygen to pass through. Oxygen is consumed by the cathode which will create a partial pressure across the membrane. Oxygen will then diffuses into the electrolyte solution.
Thus, a DO meter actually measures the pressure of oxygen in water. It can be used to measure DO in any medium.
Dissolved oxygen meters typically work by using a sensor that measures the amount of oxygen dissolved in a liquid sample. This is usually done using a probe containing an oxygen-permeable membrane that allows oxygen to diffuse into the sensor. The sensor then generates a signal that is correlated with the oxygen concentration in the sample, which is displayed as a numerical value on the meter.
An oxygen meter measures the concentration of oxygen in a particular environment, usually expressed as a percentage of oxygen in the air. It is commonly used in medical settings to monitor oxygen levels in blood (pulse oximeter) or in industrial settings to ensure safe oxygen levels for workers.
An oxygen meter measures the amount of oxygen in the blood by using a technology called pulse oximetry. It works by shining light through the fingertip and measuring the amount of light absorbed by oxygen-rich and oxygen-poor blood. The device then calculates the oxygen saturation level based on this information.
In a 1 meter cube of air, approximately 21% of the volume is oxygen. The amount of oxygen in this volume would depend on the overall weight or mass of the air in the cube.
There are approximately 6.2898 barrels in a cubic meter.
The mid-scale point of a thermocouple meter is the point at which the output voltage of the thermocouple is midway between the minimum and maximum values it can measure. This point is typically used to check the accuracy and linearity of the meter's readings.
Q-meter works on the principle of Series Resonance
1)what is the relation of total dissolved solid and conductivity of water? 2)What is the difference of the conductivity of treated water and raw water?
CLAMP METER WORKS WITH THE PRINCIPLE OF HALL EFFECT..
A dissolved oxygen meter measures the oxygen pressure in water. An anode is covered with water to halt the oxygen probe in the DO to give a reading.
Oxygen concentration in water can be tested using a dissolved oxygen meter or a chemical test kit. The dissolved oxygen meter measures the amount of oxygen dissolved in the water, while a chemical test kit uses reagents to indicate the oxygen level based on a color change. Both methods provide an accurate assessment of oxygen concentration in water.
http://en.wikipedia.org/wiki/Electricity_meter
Any fluid contains some solid in it which is dissolved in the fluid. the flow of current in the fluid is due to that dissolved solids. here the relation between electrical conductivity and total dissolved solids (TDS). so Tds meter works on the principle of electrical conductivity by measuring the electrical conductivity and relating it to the dissolved solids the TDS of any fluid can be determined.
Equipment such as a dissolved oxygen meter or a probe with a sensor is typically used to measure dissolved oxygen in water. These devices work by measuring the amount of oxygen dissolved in the water, providing a reading in units such as milligrams per liter (mg/L) or parts per million (ppm). Regular calibration and maintenance are important for accurate results.
this is good to know that there is a way i can find somthing usuful for mi studies
A dissolved oxygen meter is commonly used to measure dead zones, which are areas with low or depleted oxygen levels. The meter determines the amount of oxygen present in the water, providing insights into the extent of the dead zone.
trivector meters are used to measure kVAh and also kVA of maximum demand.it has a kwh meter and reactive kvah meter in a case with special summator mounted between them.
A dissolved oxygen meter is an instrument used to measure the levels of oxygen dissolved in a liquid, usually water. These meters typically use an electrochemical sensor to determine the concentration of dissolved oxygen in the sample.