Want this question answered?
You have a sensor at each track. Each sensor has a red or green light. Move the sensor until the light turns green. Use a string if you have to. The sensors have to "see" each other.
a green door in green light, write the colour that each of these objects will appear
No.
Mixing yellow and blue together will create light green. Adjust the amount of each color to achieve the desired shade of light green.
To get a light green color, you can mix yellow and blue together. Adjust the ratio of each color to achieve the desired shade of light green.
A green light.
The door ajar switches are located inside each door, one on the back of each door latch assembly. It is a simple one wire switch, that simply grounds the wire if the door latch isn't all the way latched. They get dirt in them that causes the door ajar light to stay on. Sometimes you can free them up by opening the door, and spraying a lot of penetrating oil directly into each latch on each door, and then opena nd close the door rapidly a whole bunch of times. See if that works before you start removing door panels.
it depends on how much of each and what shade of each color but usually you get a different shade of brown. ^ that's not my answer! however, if you mix blue and red, you get purple! If you mix green and green, you get more green! Then add some more green and you get.............tons of green!
The light is turned on by a switch on each door. Check them one at a time to see which it is, and then adjust or replace it.
hi During each Reflex session, Green Light progress is measured by a ring around the indicator light in the upper right of the screen. As a student advances through their session, the ring will fill in green. Once the ring is full, the indicator light will turn green. This means the student has reached the Green Light.
Try opening and closing each door one at a time and wait for the dome light to go out before proceding to the next door..when u get to the door where the dome light stays on, that's the one with the bad door switch
There are door switches that cause the light to go off. Shut all doors and press gently on each door to see if the light goes out. If not then the door switches will need to be removed one at a time to find the bad one.