a socket wrench and an extender.
-take a nut cracker -put nut in the cracker -squeeze together -take nut out and use for what other purpose u want to use it for
Ofcourse, it can! Use a small piece of hardwood and lay it on the fretboard (against the nut), now carefully use a plastic hammer to tick the nut off (gently). If you want to put it, or another nut, back on: just put 3 tiny drops of super glue on the bottom of the nut and hold it in place for a few seconds.
It doesn't really matter. I usually put the female half, the side with the nut on first so I don't forget to put the nut on the pipe before I put that half on the pipe.
Put it in some dirt
easiest way to loosen nut is to put the engine in gear if a manuel shift or put in park if an automatic
there is a gearbox in the middle of the rear axle with a drain nut on the bottom and a fill nut on the top
you put the frog in the coco nut and drink it all up
Ya if ur a nut job
Stripped nut can not be reused. If the nut is the kind that was put onto the hose end before the hose fitting was crimped, then the entire hose will have to be replaced along with the nut.
a nutcracker is a wooden doll dressed as a solider. you put the nut in his mouth to crack the nut note: it is also a boy's penis (the weenie. the thing they pee with)
The main problem will be the lug-nut pattern not the size of the rim. Check the lug-nut spacing before trying to put them on.