If the dishwasher is hooked into a garburetor, there is a plug in the garburetor where the hose drain attaches that needs to be knocked out. The drain hose might be plugged where it joins to the Plumbing drainage. The other problem, plumbing-wise, is the drain hose has to be fed as high as it can go under the sink and back down into the drain.
There are many stores that are available that sell a Siemens dishwasher. These stores include, but are not limited to, Lowe's, The Home Depot, and Amazon.
my dishwasher drain pump does not work
Probably not, depends on where the clog is at and how the dishwasher drain is connected. I wouldn't chance it, but the worst that will happen is the sink will fill with the water from the dishwasher.
It is not recommended to use drain cleaner in a dishwasher as it can damage the dishwasher components and create a safety hazard. Instead, consider using dishwasher-specific cleaner or vinegar to clean your dishwasher.
Some common problems include: Why does my dishwasher not drain? Why does my dishwasher leak, and why does my dishwasher not dry.
The disposal has to be in place so that the drain on the dishwasher is connected. If you do not have a disposal or are removing it, there is a extension tube for the drain that has the dishwasher tube in it. The disposal does not have to work for the dishwasher to drain. The water is run through the disposal so that any food particles get ground before going in the drain. After a while, the disposal will begin to smell if it is not run.
In centre of the base.
Most common is a center drain, but it can be at either side depending on where the drain goes into the wall. On the side closest to the dishwasher, the tail piece directly under the sink has a smaller tube in the side of it for the dishwasher drain.
If you don't have a disposal, you can get a Tail piece, the section of drain right below the bottom of the sink that has a Y on it that is the size of the drain from the dishwasher.
Probably the drain hose from the dishwasher isn't high enough to keep the water from running back . The hose should be above the level of the disposal at some point. Some states require an "air gap" which is a device that is placed in the drain line to prevent this. Some states require a simple high loop in the drain hose. Many dishwasher manufacturers are now installing backflow preventers in the dishwasher.
Garbage disposal, if one is installed, or a wye branch fitting on the tail piece of sink drain. Dishwasher drain line should have an air break or air gap before the disposal or wye branch fitting.
The height of the drain really doesn't matter as long as the hose from the dishwasher has a section that is at least half as high as the dishwasher.