0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you connect Behringer Feedback Destroyer to mixer?
mixer main out TO behringer feedback destroyer input TO speakers
How do you replace power cord on Kitchenaid 6 Qt Mixer?
To replace the power cord on a KitchenAid 6 Qt mixer, you will need to remove the back cover of the mixer to access the cord connections. Once you have access, you can disconnect the old cord and connect the new cord following the manufacturer's instructions. It is recommended to unplug the mixer and ensure it is turned off before starting the replacement process for safety.
How do you connect a Stanton Turntable and Stanton mixer?
I am buying the new dj how dou connect with speekers
Where do you connect powered speakers on a mixer is it aux send?
Yes you can connect it out of AUX send. infact that is the best place to connect it from
If you have a shower mixer 3 fittings 12 your feed pipes are hot 38 shower 38 cold 12 should you reduce the 12 cold line to 38 or just connect it to the mixer?
I would just connect it to the mixer without reducing it to 3/8".
Do you need an audio enterface if you have a mixer?
No, but you can use one to connect it to a computer.
I'm a noob to recording so if have a 9-track mixing board do I need a preamp to run a condenser microphone?
A preamp is required for all microphones, and is built in to the mixer if it accepts microphone inputs. The feature required for most condenser microphones is phantom power, a 48 volt signal that is supplied by the mixer to power the electronics inside the microphone. You must use an XLR (three pin) cable to connect the mic to the mixer to provide this power. There will be a Phantom or 48V switch on the mixer to turn this feature on and off.
Can you connect a monitor to Yamaha emx5000 powered mixer?
Yes, you can connect a passive monitor speaker to an EMX 5000.
Can you connect 6 sp2 black widow equipped peavey speakers with peavey xr800f mixer?
I have connected 4 to that mixer and it was too much. You will most likely take out the amp. if you connect 6. Two is about all it can handle.
What cable would you need to connect a behringer mx400 mixer to a behringer vt100fxh head amp?
A HDMI cable is used to connect a behringer mx400 mixer to a behringer head amp. This can be bought at just about an big store.
Which mixer has the most power?
Vitamix is a very powerful mixer, you can even put any whole food into it.
What is the energy in an electric mixer in use?
An electric mixer in use typically runs on electrical energy provided by the power grid. The amount of energy consumed by the mixer depends on its power rating and the duration of use. This energy is converted into mechanical energy to operate the mixer's motor and other components.
