0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Is vinyl tube resistant to anhydrous ammonia?
Vinyl tubing is not recommended for use with anhydrous ammonia due to the potential for chemical interaction and degradation of the tubing, which could result in leaks or failures. It is best to use tubing specifically designed and rated for handling anhydrous ammonia to ensure safety and proper performance.
Can you use a refrigerator without connecting the ice maker?
Yes. There is usually a mechanism to turn off the ice maker, either a switch, or by raising the lever that senses the ice level.
What cream do you use for an ice cream maker?
Heavy cream
Can you clean an ice maker with baking soda?
Yes, you can clean an ice maker with baking soda. Mix a solution of warm water and baking soda and use a soft cloth to wipe down the interior and exterior surfaces of the ice maker. Rinse thoroughly with clean water before using the ice maker again.
Ice maker freezes?
if the ice maker is'nt working mabe it just got over heated
What is the best ice cream maker on the market?
This depends greatly on what you are looking to use it for. If it is being used for personal use, then you could check out the EdgeStar Portable Ice Maker. If you are looking to use it for commercial use, you may want to check out a Summit machine, which would be much more expensive, but would have a much higher ice making capacity.
Will magnets on refrigerator door mess up ice maker?
No, magnets on a refrigerator door will not interfere with the ice maker's functioning. Magnets do not affect the mechanical components of an ice maker, so it is safe to use them on the refrigerator door without worrying about any issues with the ice maker.
What cream do you use for a discovery kids ice cream maker?
The heavier the cream the better the ice cream will set. It is recommended to use heavy whipping cream. That is what I use and it works well.
How long to crank an ice cream maker?
It depends on your ice cream maker. If you use a gel canister model, 20 minutes. Longer and your ice cream starts to melt. An ice and salt ice cream freezer can take a bit longer. Compressor ice cream makers take between 35-40 minutes. For more on the different kinds of ice cream makers and how they work, see The Ice Cream Maker (link below).
What do you do if ice got stuck in ice maker and it is no longer making the humming noise?
Sometimes an ice maker will stop making ice. This tip could work to dislodge the ice. The cause could be a cube that has become lodged where it should not be. Unload the freezer (pain) and use a hair dryer directly pointed at the ice maker, on high heat, for about 20 minutes. This melts the lodged cube and the ice maker works again. The humming noise could be the ice cube preventing the mechanism that pushes the ice, to make place for more, from moving. Let a technician check out the cause of the problem though.
What scientific words to use for water tubing?
h2o tubing?
Why would anyone throw out an outdoor ice cream maker?
The outdoor ice cream maker could have been broken, which would be reason to throw it away. If it wasn't broken, the previous owner may not have had use for it anymore.
