You can use a multimeter set to resistance. It should show 0 resistance or full scale deflection on an analogue meter, if intact.
You can also use a small lamp (drawing less current than the fuse) connect it to the battery with a wire, including the fuse in circuit. If the lamp lights, the fuse is Ok.
Not while it is in the fuse holder. Pull it out and if you cannot look and tell if it is blown or not, test it with an Ohm meter.
Who knows? You need to test the circuit with a test light or digital multimeter. It could be as simple as a blown fuse, or it could be a defective car stereo.
You can buy a bunch of different fuses and a tester for about 12 bucks. No way to know for sure unless you test. Look inside fuse box for diagram. Test fuse either in the panel or out. Only way to be sure.
The system failed it's self test when you started the car. If you are lucky it is a blown fuse.
take the fuse out and look for the filimate to be broken or take a 12 volt test light and with the car switched on check both ends of the fuse if only one end lights up then the fuse is blown.
It depends what fuse but yes it is possible. If it is the ignition fuse then yeah your car won't start. If it is the fuse for your horn, yeah the car will still start.
If the car is a Diesel there is 30 amp open fuse on the firewall
Look for a blown fuse.
inside the drivers side door, you will see a fuse panel door when you open the car door on the side of the dash. they're labelled, i believe it pwr wnd but test them all.
You can disconnect your 1999 Chrysler 300 car alarm by removing the car alarm fuse. The car alarm fuse can be found in the fuse box.
It is important to know how to replace a fuse in a car. The cigarette fuse in a car is in the fuse box usually labeled as accessory.
not sure but check under hood in fuse box or inside panel of car use test light to check all fuses if you have no diagram