How do you program a Guide plus universal remote without a code search button?

Answer 1

Turn the device on you want to program - the TV for instance. Point the remote directly at the TV. Hold down the TV button and the power button illuminates while also holding down the TV button at the same time. When the power button turns off, then release both keys. Now, point the remote directly at the front panel of the device, hold down the play button for 5 seconds. Did your device turn off? If yes press the stop key and you're done. If no, keep pressing play every 5 seconds until your device turns off. When your device turns off, press the reverse key on the remote and wait at least 2 seconds. The remote tries the last of the previous ten codes. Hopefully this answer solves your problem.

Answer 2

While following these instructions, keep the following in mind: * device = the component you wish to control with your remote (TV, DVD, VCR, etc.) * DEVICE = the button labeled for the component you wish to program # Turn on the device you wish to program. # Turn off all other devices in the general vicinity. # Press and hold DEVICE # While holding DEVICE down, press ON/OFF and hold them both down until the LED turns on for that device. # Release both buttons. # Point the remote at the device, press and release PLAY and wait 5 seconds or until the LED stops flashing. # If the device does not turn off, then continue to press PLAY and wait the required interval (for a maximum of 20 times) until the device turns off. # When the device turns off, press REVERSE, wait 2 seconds and continue doing this until the device turns back on. # To finish programming, press and hold STOP until the LED turns off.

Answer 3

You need to have a Code search button or at least have a list of codes. You can call the manufacturer for a list or a book. Look for a phone number and you will be able to get some help with this problem.

Answer 4

1. Turn on the first device you want to program to the Gemstar remote control.
2. Hold down the button you want to program, for example "DVD," while holding the "ON/OFF" button until the red indicator light comes on. The remote control is now in programming mode.
3. Point the Gemstar remote control at the device and press the "Play" button. The indicator light will blink for approximately five seconds as it

   searches

   

   the first group of codes.

4. Press the "Play" button after the indicator light stops blinking to check the first group of codes. Continue doing this until the device powers down.
5. Push the "Reverse" button and wait approximately 2 seconds. Continue doing this until the device turns on again.
6. Save

   

   the code setting by pressing and holding the "Stop" button until the indicator light stops blinking.

7. Repeat Steps 1 to 6 for each device you want to program to the Gemstar remote control.

Direct Code Input

1. Review the last page of the RCA Gemstar remote control user manual. This page has a list of device manufacturers. Look up your device's manufacturer to find the remote codes for your device.
2. Turn on the device you want to program to the remote control.
3. Press and hold the button you want to program, such as "SAT/CABLE," and use the keypad on the remote control to enter the first code from the list.
4. Release the button you want to program and press the "ON/OFF" button to see if the programmed code worked. The device should shut off if the code was successful.
5. Repeat Steps 3 and 4 with the next code on the list until you find a code that operates the device.
6. Program the rest of the devices you want controlled by the Gemstar universal remote control by repeating Steps 1 to 5.

Answer 5

Found this link for the AT&T 200C Remote control: http://www.anvari.org/cols/Useful_Users_Manuals/200C_Remote_Control.html

Answer 6

what are some of the codes for decibel universal remote

Answer 7

D770