I have the same problem. It stays on fine once it's on, but I need the power cord to initially turn it on. Have you found any results?
You can't. You'll just have to purchase a new Power Cord.
If a portable computer, such as a MacBook, quits when disconnected from outlet power, it probably has a battery problem. Take it to a service provider if you can not determine if the battery is dead yourself.
If the Sony MHC-GX450 will not turn on and the power button only flashers, check to make sure the cord is plugged into the unit all the way. This stereo has a removable power cord that might not be fully attached.
You will need to use the power cord and/or the battery in order to turn the laptop on.
Don't know. but... unplug the power cord, then hold CANCEL and COLOR COPY while plugging the power cord back in. That should do the trick.
When installing dishwasher power cords, it is important to follow these safety precautions: Ensure the power cord is the correct type and rating for the dishwasher. Turn off the power supply before installing the cord. Avoid overloading the electrical outlet by using only one appliance per outlet. Keep the power cord away from water sources to prevent electrical hazards. Inspect the cord for any damage before installation. Follow the manufacturer's instructions for proper installation.
When you turn your Macbook on it automatically goes to the desktop. No shortcut needed.
There is a power switch on the guitar
To properly install a dryer power cord, first make sure the power is turned off. Remove the access panel on the back of the dryer. Connect the power cord wires to the corresponding terminals, usually color-coded. Tighten the screws securely. Replace the access panel and turn the power back on to test the dryer.
To properly perform a dryer cord installation, first make sure the power is turned off. Remove the old cord by disconnecting it from the terminal block. Attach the new cord by matching the wire colors to the terminal screws and tightening them securely. Finally, plug in the cord and turn on the power to test the dryer.
To install a 4 prong dryer cord, first make sure the power is turned off. Remove the old cord by disconnecting it from the dryer. Connect the new cord by matching the colors of the wires to the corresponding terminals on the dryer. Tighten the screws to secure the connections. Finally, plug in the cord and turn on the power to test the dryer.
Melt salt and get a cord and connect it to a power plug. DO NOT turn on the power yet. Get a carbon electrode and a steel electrode and plug it in the socket of the cord. Turn on the electricity. Put both electrodes in the molten salt. This is going to produce large amounts of chlorine gas so do this outside.