WD-40. I find using an alchohol based cleaner real useful for sticky marks left by sticky tape, if you cant find any or don't have any to hand try spraying perfume or aftershave on a dry cloth and rub at the mark for a few minutes and the sticky residue should slowly rub off, if you want to find the right product also try searching on Google for a product called sticky stuff remover. hope this helps
You pull it off and remove the residue with Goof Off.
Use Goof Off.
WD-40 work great
Tape leaves residue because the adhesive on the tape bonds with the surface it was attached to. Over time, this adhesive can break down and leave behind a sticky residue when the tape is removed. Other factors such as heat and pressure can also contribute to residue being left behind.
Use WD40, or Lemon Oil
You can use a product called "Goof Off" that can be found in hardware departments or home fix-it stores. It contains a chemical xylene that helps dissolve glues. Your other option is to use a piece of tape, like duct tape or masking tape, and by repeatedly sticking the tape and removing it from the sticky spot it'll pull up the residue.
Duct tape will leave behind a sticky, gummy residue that embeds into the carpet fibers. To get rid of the residue, scrap as much as possible with a butter knife. Place a damp cloth on the spot and rub a warm iron on it. Use a goo remover on the remaining residue.
One way to get surgical tape off the skin rubbing alcohol can be used to remove the sticky residue. The use of an exfoliator can also remove surgical tape residue from the skin.
You take a sharp razor and scratch off the left over tape residue. works everytime, and leaves nothing behind.
Dell has coupon codes to get a certain percentage or money off their products. They are usually not specifically for computer monitors though.
You can use rubbing alcohol or a mixture of water and vinegar to remove tape residue from a binder. Apply the solution to a cloth and gently rub the residue until it lifts off. Avoid using harsh chemicals that could damage the binder.
I am almost positive you need a dual monitor card to run tow monitors off the same computer, because if you don't have a monitor card then you wouldn't be able to run the monitors at all