answersLogoWhite

0


Best Answer

The maximum power of a class 2 power can be between 40-50v. You should always make sure you are aware what is the maximum output for your electronics.

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the maximum power output of a class 2 power supply?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Information on class 2 power supply.?

*Class 2 compliance requires a maximum power output availability of less than 100 watts for the component. Class 2 defines the portion of the wiring system between the load side of a Class 2 Power Supply (beginning from the outside of a cabinet or machine) and the connected equipment. Due to its power, current and voltage limitations, a class 2 circuit considers safety from a fire initiation standpoint and provides acceptable protection against electric shock. *Only the load side of a power supply with a nameplate rating of less than 100VA (or 5 times Vout if output voltage is lower than 20V) can meet the class 2 circuit requirements.


What is the peak load of a power supply?

A: A power supply when designed it will have some nominal criteria and also some maximum output power available which reflect to the peak load that it can stand without burning up


Power supply units are rated in?

Power supply units are rated based on their output and efficiency. When more equipment is connected, a higher output power supply is needed.


Output DC power supply?

????????????????


Is it possible to replace 300 watts power supply to 1000 watts as maximum output?

yes. because the more storage, the more ability the computer has.


Is power supply input or output devices?

Output - because it is outputting power to the rest of the device


Is the power supply for a Digitech whammy II 9v or 12v I need the specs for the power supply?

whammy 2 specs. ps750 class 2 transformer Ac-Ac power supply input: 120vac 60Hz 12w output 9v AC 780mA


What size fuse should be used for 2 amp power supply?

If the 2 amps is the output amperage of the power supply, the maximum that should be drawn from the unit is 2 amps. The load amperage that is connected to the power supply should govern the amperage of the fuse used. There is not much range there, the fusing could go from .25 to 2 amps. If the input amperage is 2 amps then the input and output voltage of the power supply should be stated.


What to do if the power supply is too low?

Obtain a power supply that has the correct output voltage that you need.


What is the formula of efficiency?

Efficiency is typically calculated as the ratio of actual output to maximum possible output, expressed as a percentage. The formula for efficiency is: Efficiency = (Actual output / Maximum possible output) * 100%.


When switch is off of power supply output shown on the multimeter is negative voltage from power supply?

Yes.


Why power supply an output device?

because it is devices