0
Add your answer:
Earn +20 pts
What is the output of the command used to test a nic card?
PING is what you need to use . Ping 127.0.0.1
Describe the correct usage of the PING command to help troubleshoot a home network?
Use the PING (and current IP address) command to execute a loopback test on a NIC
How do you test a Ethernet port?
to check if your Ethernet card r INTERNET is working r not, just type the following in command prompt: ping 127.0.0.1 This command is basically used for self test of NIC(Network Interface card) card
What is the lo device displayed in the ifconfig command?
it's the loopback address. The IP address listed under it can be pinged to test to see if your NIC is working
What is the command used to find the MAC address of the NIC?
ipconfig
What command would you run from a windows command line to verify that a nic can send and receive ipv4 packets?
ping 127.0.0.1
Is NIC a power on self test device?
yes
What are the two ways to use the ping utility to test a local computers NIC?
go to command prompt and type in either Ping Loopback, or Ping 127.0.0.1 or Ping another device's IP Address
What device is used to perform a loopback test on a nic?
base1000
Where do you check in network OS that the newly installed NIC is working properly?
ping 127.0.0.1 in command mode, this is know as the loopback address. If the pings are successful then the nic is working properly
The physical address is a fixed number associated with a device's nic it is initially assigned at the factory and stored in the nic's on-board memory you can find a nic's mac address through your co?
if by co you mean computer then yes you go to command prompt and type in "ipconfig/all" and you go to "network interface(or whatever it calls your nic)" and it will show u the physical address of your nic
What commands would test the loopback adapter of an internal NIC?
ping 127.0.0.1
