answersLogoWhite

0


Best Answer

A fused jumper wire is just a wire with or with out alligator clips that has a fuse on it. It can be either buss or blade fuse. You can make one with some parts at autozone or similar parts store.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is a fused jumper wire?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is a fuse wire?

A fused jumper wire is just a wire with or with out alligator clips that has a fuse on it. It can be either buss or blade fuse. You can make one with some parts at autozone or similar parts store.


Can you use a normal wire instead of a fused wire?

yes but fused wire is safer.


How do you tell if sunroof motor for 97 grand prix is bad?

unplug motor run fused jumper from batt and touch to two wire plug on motor


How do you make a fused jumper wire?

To make a fused jumper wire you need a couple parts: In-line fuse holder. Solder. Soldering iron. Wire. Which ever clips you want. I used alligator clips. and heat shrink. What you want to do is take the fuse holder, Strip the ends back a little bit (Most of the times they come pre-stripped), next, take a chunk of your wire and then strip it the same amount. Once you do that, you need to solder them together (I typically twist them then solder them) Once soldered together, slip a piece of heat shrink over the end of the wire to cover the soldered joint, then shrink it with a heat gun or a lighter. Be careful as it'll get hot! Do that for the other side of the fuse holder. Then add your clips on the ends. With that, you have your fused jumper wire.


How do you make fused jumper wires?

To make a fused jumper wire you need a couple parts: In-line fuse holder. Solder. Soldering iron. Wire. Which ever clips you want. I used alligator clips. and heat shrink. What you want to do is take the fuse holder, Strip the ends back a little bit (Most of the times they come pre-stripped), next, take a chunk of your wire and then strip it the same amount. Once you do that, you need to solder them together (I typically twist them then solder them) Once soldered together, slip a piece of heat shrink over the end of the wire to cover the soldered joint, then shrink it with a heat gun or a lighter. Be careful as it'll get hot! Do that for the other side of the fuse holder. Then add your clips on the ends. With that, you have your fused jumper wire.


Where is fuel pump relay on vauxhall astra mk 4?

Under the front bonnet, to the right of the engine bay. They are normally purple in colour and i think the fuel pump relay has a fused jumper wire beside it.


A jumper wire should be used to bridge the electrical ground across?

A jumper wire should use to bridge electrical ground across?


Can 12- 3 wire be used for 20' jumper cables?

No, you need at least 8 gauge for jumper cables.


Does all romex have a ground wire?

Some older wire does not have a ground. All you can do in that case is use a jumper wire to connect the ground to the neutral.


How do you hot wire a 1982 Dodge truck?

Take a jumper wire from Battery + to coil +Then jump solenoid on starter


How to bypass fuel pump relay 98 Bui Park Avenue or were to connect a jumper wire?

Fuel pump relay 98 Buick at Park Avenue can be bypassed by locating the jumper wire that runs from under the dash to the "reader", and then create the "resistor pack" to jumper accross the wires.


What is a 0 ohm link?

A zero ohm link is a piece of wire, a jumper.