Show IP route
The Ping command sends a small packet of data to a destination IP address and waits for a response. It measures the time it takes for a packet to travel from the source to the destination. This command is typically used to check if a network device is online and responding to requests. On the other hand, the Trace Route command sends a series of packets to a destination IP address and tracks the route that each packet takes. It identifies each router or hop that a packet goes through on its way to the destination. This command can be used to diagnose network latency issues or identify where data is being lost. While the Ping command only provides information on the time it takes for a packet to reach the destination, the Trace Route command provides more detailed information on the network path and any delays or losses that occur along the way. In summary, both the Ping and Trace Route commands can be useful in troubleshooting network issues, but they serve different purposes. The Ping command is a simple tool for testing connectivity to a destination device, while the Trace Route command provides more detailed information on the network path and any issues that may be occurring.
The "show ip route" command in Cisco devices will display the administrative distance of routes along with other routing information.
No packet can be forwarded without a route. Whether the packet is originating in a host or being forwarded by an intermediary device, the device must have a route to identify where to forward the packet.
The tracert command is a command prompt command that's used to show several details about the path that a packet takes from the computer or device you're on to whatever destination you specify.
The tracert command is a command prompt command that's used to show several details about the path that a packet takes from the computer or device you're on to whatever destination you specify.
The tracert command is a command prompt command that's used to show several details about the path that a packet takes from the computer or device you're on to whatever destination you specify.
Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....Assuming you have a Cisco router, you add a static route with the command ip route.... Therefore, you delete it with the command no ip route....
Compared to RIP, EIGRP has a lower administrative distance.
show ip route
traceroute is usually used for this purpose.
your command would be show ip route or sh ip route static