If you have a mix of RAM devices with different speed capabilities on a motherboard, the memory bus will work on speed of the slowest memory. Then it does not matter which slot you put which memory.
- Neeraj Sharma
the teacher should act a controller
There should be a flap that lifts up ontop of the wii and there are 4 slots to plug the controller into put it into the closest one to the power button. Not all wii's have that flap. The newer ones with new mario bros. wii dont have the flap, so the controller wont work. Found this out from gamestop.
Even if the battery is low connecting the USB controller cable should allow the controller to connect when you press the PS3 emblem on the controller. Without another controller you can not tell if the PS3 or controller is the problem and does not work
I would buy the Kinect for your Xbox but not a modded controller as you will get suspended if you play with a modded controller.
Depends on what processor you're using. Go to the manufacturer's site and find the product, it should tell you the socket that the processor requires. Any motherboard with that socket will be compatible
Not enough information.
in the processor it self it should say the make and model. like Intel Pentium 4 or AMD 64.
The graphics processor should already be in use if your driver is installed. if the driver is not installed then you can download and install it from the respective processor brand.
Currently the Intel i5 processor is the most famous processor being used in PCs and notebooks. You should look for a laptop with this processor, which will speed up everything you do.
Press the PS button in the centre of the controller, then plug the controller charging cable into the controller (with the other end of the cable connected to the cosnole), it should register after a couple of seconds.
It only takes a couple minutes to program a wireless controller. Simply add the batteries to the controller, turn on console and controller, press the small button on console front and and small button on controller located close to the LB button on the controller and that should be it, you've programmed your controller.
There is no technological difference but the only difference should be how it is phrased