0
What else can I help you with?
What device is used to perform a loopback test on a nic?
base1000
Which are two types of nic's?
Ethernet NIC: A network interface card (NIC) designed to connect a device to an Ethernet network using an RJ45 port. Wireless NIC: A network interface card (NIC) equipped with wireless capabilities to connect a device to Wi-Fi networks.
What are peces of hardware that connect the wire to the network device?
It's called a Network Interface Card, or "NIC" for short.
What is the lo device displayed in the ifconfig command?
it's the loopback address. The IP address listed under it can be pinged to test to see if your NIC is working
What is the command to test nic?
pinglocalhost
The device that connect a device to the media?
NIC (Network Interface Card)
The device that connects a device to the media is called?
NIC (Network Interface Card)
Is NIC a processing device?
In computer hardware, NIC typically stands for a network interface card, commonly also called the network card.While a typical NIC may include some processing capability, this is normally very limited and doesn't qualify the NIC as a general purpose processing device.
What is a NIC and what is it used for?
NIC stands for Network Interface Card. It is connected to the motherboard of the computer. It provides the device with a MAC address and allows a device to access a computer network such as the internet.
What is the source's NIC serial number?
The NIC serial number is a unique identifier assigned to a Network Interface Controller (NIC) and can typically be found on the device itself, in the device's settings, or through system information tools. To locate it, you can check the NIC's documentation, the manufacturer's website, or use command line tools like "ipconfig" on Windows or "ifconfig" on Linux. If you need help finding a specific NIC's serial number, please provide more details about the device.
Why is it important to have NIC as a communication device?
It is important to have a NIC as a communication device because it serves as the gateway of information that you send/receive on your computer. Without it, you won't be able to interact with other computers or the Internet.
What are the steps to making a peer to peer network?
The steps are:Put a NIC device in every system that will connect to the networkCreate a cable that goes from the NIC to a connectivity device, such as a hub or switch.Install a networking protocol on each systemConfigure the networking protocol to name each device and put an appropriate network address on each NIC card.That's it! You're done.
