answersLogoWhite

0


Best Answer

This information is intended for experienced users. It is not intended for basic users, hackers, or computer thieves. Please do not try any of following procedures if you are not familiar with computer hardware. I'll not be responsible for the use or misuse of this information, including personal injury, loss of data or hardware damage. So use it at your own risk.

A. By Using the Motherboard Jumper:

In most motherboards CMOS battery is soldered, which makes it difficult to remove the battery. In this case we use another method.

Almost all motherboards contain a jumper that can clear all CMOS settings along with the BIOS password. The location of this jumper varies depending upon the motherboard brand. You should read your motherboard manual to check its location. If you don't have the manual then look for the jumpers near the CMOS battery. Most of the manufacturer label the jumper as CLR, CLEAR, CLEAR CMOS, etc.

When you find the jumper, look carefully. There will be 3 pins and the jumper will be joining the center pin to either left or right pin. What you need to do, is remove the jumper and join the center pin to the opposite pin. e.g. if the jumper joins center pin to left pin, then remove it and join center pin to right pin. Now wait for a few seconds and then again remove the jumper and join the center pin to left pin.

Make sure to turn the PC off before opening the cabinet and resetting the jumper.

B. By Using Software:

I have found that BIOS/CMOS Password Recovery Tool is the most effective.:

BIOS/CMOS Password Recovery Tool is a program that works instantly to remove any lost or forgotten BIOS/CMOS password. Simply boot your PC to DOS and execute the program, and get access to forgotten BIOS/CMOS passwords in just seconds

BIOS/CMOS Password Recovery Tool Service

User Avatar

Wiki User

14y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

10y ago

There should be a jumper on the motherboard that you can change to the reset BIOS mode and then power it up and it will flash the BIOS back to the original state. Some BIOS should also have a option in the actual BIOS settings.

This answer is:
User Avatar

User Avatar

Wiki User

15y ago

Pheonix BIOS has to be the highest chosen BIOS for most computer manufacturers. In the event of an extreme virus or major malfunction to the motherboard, a simple low cost resolution is purchasing a new one. The ability to "Flash" the motherboard is a task even the most qualified expert cannot guarantee. The manufacturer themselves has went outside their efforts and purchsed the software from the particular BIOS carrier. The file has to be saved on the CPU in a manner that is compliant with your version of BIOS. Meaning the file to revert your BIOS to its original state has to be saved in a manner that version of your BIOS understands. Then an updated BIOS is added to the things to do list because the old version is probably outdated and you will attract the same virus or worse again. Good news is that newer motherboards have updated this whole process and even getting the reset or upgrade function has been added to the bios. Ask the retailer you may purchase a new one for to show you on a display model if possible. Contact me through the bio page for even further details.

This answer is:
User Avatar

User Avatar

Wiki User

15y ago

== == == == == ==

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you reset BIOS?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you get to BIOS to reset them?

You can press the Delete or F2 key to get into bios and then you can reset the settings or you can reset CMOS. This guide shows you how to reset CMOS - http://www.eteknix.com/how-s/how-reset-cmos-122/


What is BIOS battery?

The function of a bios battery is basically to reset your bios if something goes wrong and you corrupt it. Bios batteries usually contain a little bit of information on them. Therefore, when you remove a bios battery, it goes back to default settings. **Note** removing a bios battery is usually a last resort to reset your bios. There are several other ways to reset your bios such as a jumper cable or (included in some never motherboards,) a reset bios switch.


Is it possible to remove the bios battery on dell vostro 3300 to remove the bios admin password?

No, removing the bios battery on a laptop will not reset bios settings.


Is there anyway to reset the BIOS password on a Toshiba 460CDT laptop if you have forgotten it?

The best method to reset a BIOS password depends on what BIOS the computer has. Common BIOS's include AMI, Award, IBM and Phoenix. Numerous other BIOS's do exist, but these are the most common. Some BIOS's allow you to require a password be entered before the system will boot. Some BIOS's allow you to require a password to be entered before the BIOS setup may be accessed. The general categories of solutions to reset a BIOS password are: Using a Backdoor BIOS Password Resetting the BIOS Password using Software Resetting the BIOS Password using Hardware Vendor Specific Solutions for resetting the BIOS Password


My booting password forgot how to open?

If it's a desktop computer and you forgot the BIOS power-on password, you can reset the BIOS by closing the "cmos reset" jumper on the motherboard.


You just reset your stat password on your gateway Pentium manufactured 8 21 99 how do you reset your BIOS settings?

On windows? Wrong category. But if it's your computer, just take the battery out of the computer's motherboard and the BIOS will reset leaving no password for the BIOS login. If its a phone then it's not possible.


How do you toggle the BIOS reset jumper?

The BIOS rest jumper is toggled by placing the jumper of the specific jumper pins. This causes the connection to close the circuit and trip the internal reset.


What will happen after you reset your BIOS?

Once you reset your BIOS the computer will just carry on with the default settings, which means if you created a RAID it will no longer read it as one hard drive and instead two.


Changing or 'shorting' a jumper on the motherboard to reset the bios what is a 'jumper'?

A jumper is a small metal and plastic device used to complete circuits on the motherboard by 'shorting' pins. The BIOS reset jumper is one example.


What should you do if you get the POST error CMOS checksum bad?

cmos ram might be corrupt. run bios setup and reset bios to default settings. if it occurs again try, flashing bios.


What are the functions of Motherboard?

jumper that set the cpu speed or reset the BIOS memory


Hack bios password?

Reset the CMOS on the motherboard, that should clear all data set in the BIOS. Apart from that, you can't "hack" the bios password. Don't hack anyway. It is bad and a serious offence.