0
Are standard access listS confIgured close to the source or destination address?
Wiki User
∙ 12y ago
Standard access lists are placed close to the destination. Extended access list are placed close to the source. This is because extended ACL's look at the source and destination IP address, whereas standard ACL's look at the source IP address only.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Which variable is permitted or denied by a standard access control list?
destination mac address
How do extended access control list differ from standard access control list?
Standard Access Control Lists (ACLs) only allows you to permit or deny source addresses. You can not block based on protocol, port, or destination. Extended ACLS allow you to block traffic based on source address, destination address, source port, destination port, and protocol.
How is a firewall configured to allow Web access to a Web server?
The firewall typically is configured to allow inbound connections on a specific port to a particular IP address on the network (the server). This usually means that port 80 and/or 443 will be configured to allow access to the server from the Internet.
What type of IP address should be configured on a wireless access point so that it can always be located by the devices that it serves?
Static IP Address
Which combination of a Layer 2 address and a Layer 3 address will enable access if Host A wants to access the Internet?
Destination MAC: 0030.8517.44C4 Default gateway: 172.16.1.1
Which statements describe characteristics of extended access lists?
They check packets by source address They check packets by destination address
What is ACL stands for in networking configuration?
ACL stands for Access Control List. ACLs are used in networking to control which types of traffic are allowed to pass through a network device, such as a router or firewall. They can be configured to permit or deny traffic based on criteria such as source IP address, destination IP address, protocol, and port number.
How you can access to specific computer that locate withing wireless network?
You can use its IP address or network name (your firewall has to be configured properly).
What is a valid reason for a switch to deny port access to new devices when port security is?
The denied MAC address are statically configured on the port
What is the valid reason for a switch to deny port access to new devices when port security is enabled?
The denied MAC address are statically configured on the port
How do you write an ACL for cisco routers?
Access-lists are used for limiting the traffic say mainly for security purpose. Using access-list you can deny or permit the traffic from source address based on standard access list or deny or permit the traffic by classification of source or destination ip address, or by protocols . these are written in sequential order. So order of statement is very important . We should be clear of what to permit or deny .. sample config Standard access-list Router(config)#access-list 5 <permit> or <deny> <source ip address> Extended access-list Router(config)#access-list 111 <permit> or <deny> <protocol> <source ip address> <destination ip address> After creating access-list it will not be useful without applying on the interface where the traffic runs along the path. these should be applied in inbound direction or outbound direction of the interface as per our requirement. Most importantly when u want make changes , copy to text editor or notepad , do changes on them and remove the access-list config in the router and copy them fresh from the notepad.
How do you place an address in the GPS satellite?
To input an address into a GPS satellite system, access the maps or navigation app on the device and select the option to enter a destination address. Then, type in the full address including street name, number, city, and state, and follow the prompts to set it as your destination for directions.
