The ITT Homework slot.
Some models have one, and some do not.
Not both at the same time. Most motherboards will be able to support both types of RAM but DDR RAM is much better, due to the double data capability it has. Since RAM prices are quite cheap it would be better if you throw out your SD RAM and buy DDR. No you cannot use both ddr ram and sd ram on the same pc. You have to use either or depending on the motherboard. The slots are different. You can determine what type of memory you have by entering setup in the bios when you turn on your pc. DDR Ram has a slot in the very center of the chip that forms to the slot you plug it into. SD ram has a slot on the chip off set the middle. Hope this answers your question. No you cannot use both ddr ram and sd ram on the same pc. You have to use either or depending on the motherboard. The slots are different. You can determine what type of memory you have by entering setup in the bios when you turn on your pc. DDR Ram has a slot in the very center of the chip that forms to the slot you plug it into. SD ram has a slot on the chip off set the middle. Hope this answers your question
When in doubt, put it in the green socket. It might also be marked as "speaker" or "headphones." You can try the headset plug in front if there is one there. Otherwise, try the green or "speaker" socket in the back if there is one there.
yes,we can increase it to 1GB by means of replacing 256MB into 1GB.we cannot add the size into one slot. for eg,if your ram size is 512MB means ,there are 2 slots in your CPU each of 256MB,u can replace one slot into 1GB .
Yes, the larger slot is a polarity slot that is supposed to connect the plug in device to the neutral wire. If the device is a lamp it would make the shell of the lamp the neutral wire connection and the center pin the "hot". If the two wire plug has a moulded plug on it, look for a tracer on the devices power cord. It will be a raised rib or a white tracer on the conductor that is the neutral. Position the two blade plug into the receptacle with the identified conductor into the larger slot, this will give you the proper polarity configuration that the manufacturer recommends. New plugs (caps) today all have a ground pin connected to them and can only connect to the receptacle in one position.
You can replace PC keyboards by disconnecting the old one from the USB slot and plugging the new keyboard into the USB slot. There usually isn't any drivers or anything that you need to install, it's plug and play.
I assume it is leaking or you would not be removing it. You can remove it by driving a screwdriver into the middle and prying sideways. hit it on one side so that it flips sideways but hopefully not right into the cooling jacket, then grip the exposed edge and lever it out with pliers.
No, you have to have 2 Nintendo DS's to be able to trade but you do get an a attachment for you're DS that allows you to plug it into the DS card slot and have two DS card slot's
There are a couple of ways to draw a donkey's face sideways. One way is to draw it normal and turn it sideways.
I believe that the spark plug is burning out because of the volts and the fact that it is p;ugged into a higher voltage slot. You pretty much need a new cord with the same number of vlts that it can hold. :)
Some plugs are meant to go in one way only, so you might be trying to insert it upside down or from an angle. Gently easy the plug into the slot - if you have to start using force then you are not doing it right.
only ds in slot one and gba in slot 2
The only time slot one is empty is when you have not received your starter yet. Otherwise you must always have a Pokemon in slot one.
It's a plug. One end goes into the the cigarette lighter outlet of the car, and at the other end there's a slot for an USB connector.
The distributor has only one plug and one screw. You should note the position of the adjustment slot and the exact position of the rotor, and make sure the new one is put in exactly the same.
a round one that you can order online