A jumper is used to complete a circuit on a motherboard or other device and thus signal a certain mode of operation, such as "the BIOS should be in recovery mode" or "this hard drive is the Master device."
Put the jumper clip on different pins
You can watch the movie jumper in the movie houses, in DVD's or in the internet.
A jumper is closed (on) if the cover is in place, connecting the two pins that make up the jumper; a jumper is open (off) if the cover is not in place.
Jumpers look like plastic caps with a piece of metal inside, just like those in the above photo. They are usually black, but they can be a number of other colors. Their purpose is for making selections on hardware.
It consists of adding, removing or repositioning a metal clip to obtain the needed setting.
The purpose of using an RH and RC jumper in a thermostat installation is to connect the heating (RH) and cooling (RC) systems to the thermostat, allowing it to control both functions effectively.
A bios or cmos jumper
"Jumper Parking" is when you have a Jumper hanging on one pin for safe keeping, rather than using it to turn a Jumper Setting on.
Find directions for a jumper and knit a blue jumper. If you are skills you could knit the Ravenclaw symbol onto the jumper otherwise you can buy the badges and sew them onto the jumper.
Applied physics! The jumper uses muscles to generate energy. This energy is used to overcome gravity, and the when gravity returns the jumper to the tramp, the tramp "catches" the jumper. In catching the jumper, the tramp stores the jumper's energy in its springs, and then returns it to the jumper. Simple and easy.
Leon Jumper in 1863
large loose jumper
Base Jumper?
A grasshoper is a great jumper
Two examples are resetting the BIOS to the default settings and swapping between two different BIOS chips for boards with multiple BIOS.
Obviously, it doesn't have any, with the possible exception of a BIOS recovery / config jumper.
The BIOS rest jumper is toggled by placing the jumper of the specific jumper pins. This causes the connection to close the circuit and trip the internal reset.