There's a 12V and a 5V supply. The 5V is for the logic. The 12V supply is for the motor.
12v 1000mA means that the maximum output of that unit is 1000 milliamps at 12 volts. 12v 150 mA means that the maximum output of that unit is 150 milliamps at 12 volts. So if you need 150 milliamps at 12v either will do. BUT if you need over 150 milliamps at 12v then you must go for the 1000 mA unit. By the way there are 1000 milliamps in 1 amp.
A 12v Mini Drill is just a small drill with a 12 volt power supply. This can either be with an a/c adapter or rechargeable 12 volt battery.
+12 volt , -12 volt, + 5 volt, - 5 volt, and + 3.3 volt.
Typically computers are connected to a UPS. Rarely they are connected to direct power supply. The UPS may provide 110V or 220V supply oscillating at 50Hz and 60Hz. These values depend on the particular country's power supply standards. The electricity supply then goes to SMPS in case of desktops. SMPS is a control circuit that switches the load current rapidly on and off in order to stabilise the output voltage. Typically different components get different levels of voltages. It may range from 1.5V to 12V. Note that computer components run on DC supply not AC supply so it is converted by SMPS. In case of laptops the AC supply is converted to DC and then given to battery which further supplies the laptop components.
can a 12v lawn mower sealed battery be charged with 12v battery charger use on cars
12v in cars. Can be 24v in lorrys. 6v cars were phased out in the 50's.
You can put 12V across the terminals and see if you can hear it. Or do you mean check the flow pressure, in that case you really need to connect a pressure guage to the fuel line.
50 resistors
The input power of a computer Power Supply is usually 110-240VAC. The power supply usually transforms the input voltage into 3.3V, 5V, and 12V...all in DC. Different components require different voltage...either (1)ONE of a combination of these. 12V is one output voltage of the PSU(Power Supply)
If the motor is designed for 120V or 220V whatever the case, it will function properly.If it is a 12V motor and you supply 120V it will make a mess and you will probably get hurt from flying debris!
Sounds like the computer isn't getting the needed 12v power when the vehicle is turned off. Check fuses and wires, Verify that you get 12v on the power wire, not the ignition wire. The Ignition wire only works when the ignition is activated. The 12v power wire provides power for the simple data, as in date and time, and saves that you have put in.
Probably - most ride ons are 12v the same as cars. Just check it is not an older 6v battery first - pull it out and read the label. If it is 12v, connect those leads and fire it up!
No. If the transformer outputs 14.5V it is very unwise to hook it up to a 12V Monitor. The transformer needs to be able to output 12v, the polarity needs to be correct (e.g. tip + tip -), and it must be rated to provide at LEAST the required amount of amperage.
As long as they are the same volt you should be able to change the wattage, I am assuming this is not on a vehicle in which case you should always check the department for motor vehicles for regulations.
As long as they are the same volt you should be able to change the wattage, I am assuming this is not on a vehicle in which case you should always check the department for motor vehicles for regulations.
my 2000 model doesnearly all cars do, apart from the odd few that run off a chain