answersLogoWhite

0


Best Answer

they are usually found close to the blower motor.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the heater resistor on a 1990 freightliner truck?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the blower motor resistor on a 1990 Chevy pickup?

In the truck!


Where is the Location of heater fan blower motor resistor 1990 ford F250?

under the hood hinge on passenger side in the corner going into the cab at an angle


Where is the blower motor on a 1990 Dodge Dakota located?

in the dash but check the resistor 1st the blow e.z. it is in engin comp. passinger side on heater core lines it looks just like a water heater fuse


How do you change a heater core on a 1990 che vy truck?

That job is known to be a scourge among mechanics. Pay someone to do it, trust me.


Why the heater of a 1990 dynasty works only on high settings and after does not work at all?

If you are saying the Blower Motor only works on high, then your problem is a defective Blower Motor Resistor Pack. Replace it.


Replace heater core on 1990 fordF-150 truck?

1- Drain coolant. 2- remove heater hoses from core inlet and outlet pipes in engine compartment. 3-remove screws and heater core cover. ( right side lower passenger compartment ) 4- carefully lower core out of heater unit. This old of a truck it would be wise to replace both heater hoses. Use antifreeze as a lubricant to install heater hoses to new core inlets.


1990 ford 5.8 truck no spark but fuel?

1990 ford truck no spark


Where is blower motor resistor at Nissan Pathfinder 1990?

under the glove box. on the heater assembaly there is a rectangle piece of plastic with 2 bolts and a 4 or 5 pin heavy gauge wire harness attached to it


What are the options on a 1990 Chevy truck?

depending on model of truck.


What does NAPA oil filter 1394 fit?

1990 Ford 250 truck


Why wont W124 230 E Heater blower work?

i am working on the same problem at my 230 ce 1990 right now (w124). the first thing you have to check is the blower motor, and when you have got that out of the car, you see a panel, straight trough that panel there is a resistor, if thats not burned, you can check any wires going in and away from the resistor. in my case it is the panel to the heater that is broken. Good luck! :) (my english is not the best because im Norwegian)


Does a 1990 dodge B-250 van have a blower resistor?

Yes